There are a couple of types of wiper arms used by GM. One is held on the shaft with a clip, and the other has a nut to hold it.
# Pry the plastic cap off the nut at the base of the wiper # Unscrew the nut # Use a small gear puller (battery clamp puller might work) to pull the wiper arm straight off the shaft. Do not pry under the wiper arm to pull it off. If you do, you will break the plastic cowl underneath and still will not have the arm removed.
# Lift the arm away from the glass # Using a flat screwdriver, slide the locking clip down. The arm should stay up. # In theory, the wiper can now be pulled straight off the shaft. In practice, the wiper arm is likely corroded all to hell and stuck to the shaft. You will need penetrating oil and possibly heat to get it off. You may even have to cut a slit in the wiper arm base.
how do you replace wiper crank arm 2001 chevrolet impala?
Remove the wiring harness from the wiper motor. Remove the wiper arm linkage. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
I think you would just have to replace the whole wiper. It's routine maintenance to replace wipers, especially if you live in New England, where there's a lot of snow and rain.
removal of rear winshield wiper arm on 07 outback
The windshield wiper arm is held in place by a retaining clip. Hold the retaining clip in and the windshield wiper arm will come off. Put the new windshield wiper on and read lease the retaining clip.
To replace the wiper arm on a Mazda 626, first lift the wiper arm away from the windshield until it is at a 90-degree angle. Locate the small tab or clip on the underside of the wiper arm where it attaches to the wiper motor shaft, press it to release the arm. Carefully pull the wiper arm off the shaft, then align the new wiper arm with the shaft and push it down until it clicks into place. Finally, lower the wiper arm back onto the windshield and ensure it is secure.
Begin by removing the traveling arm retaining bolt from your 1998 Chevrolet Cavalier wiper motor. Remove the wiper motor retaining bolts. Remove the wiper motor wiring harness. Reverse the process to install your new wiper motor.
how do get rear wiper arm off fiat punto grande
1. Bad Wiper Blade(s). 2. Improperly connected to wiper arm. See related link for troubleshooting. 3. Wiper Blade is binding on wiper arm for some other reason other than improperly installed. 4. Improper Wiper Arm Tension - clean and lubercate wiper arm hinge area at base of arm near hood. Replace spring if cleaning and lubercating doesn't work. 5. Bent wiper arm. BE CAREFUL HERE - THIS IS A LAST RESORT. Try bending arm back or replace arm.
There is a plastic cap at the base of the wiper arm. You will need to pry it up to reveal the nut underneath. Remove the nut and pry up. BE VERY CAREFUL NOT THE HIT THE WINDSHIELD WITH THE WRENCH.
On what make/model/year vehicle?
yes