If you don't see any gas leaking or smell gas :
- push the reset button down if it has popped up on the top of the switch
- turn your ignition key to the RUN position for a few seconds and then turn your ignition key to the OFF position
- make another check for any gas leaking or the smell of gas
- if none , go ahead and start your engine
how to reset cutoff to fuel pump
In the front passenger footwell by ( or behind ) the kick panel
Were is the antitheft switch
push the button down
mine does
On a 2000 Ford Ranger the only engine that uses a timing BELT is the 2.5 liter four cylinder engine ( I have no idea of what you mean by a " delay switch " )
The fuel pump shut off ( inertia switch ) is located in the front passenger footwell behind the kick panel on a 1999 Ford Ranger
Because it had tripped for whatever reason.
where is the fuel reset button on a 1994 ford ranger Driver side trunk. behind plastic covering
According to the 2000 Ford Ranger Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , BY the kick panel * but the drawing Ford has indicates that it is BEHIND the kick panel
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
I have a 2000 Ranger and the reset button is in the passenger side kick panel. If you look between the glovebox and the floor it should have "Fuel Reset" labeled on the kick panel.