To reset the engine management light on a Nissan Micra, you can use an OBD-II scanner to clear the diagnostic trouble codes (DTCs) stored in the vehicle’s computer. Alternatively, you can disconnect the car battery for about 15 minutes to reset the system, but this may also reset other settings. After reconnecting the battery, start the vehicle to see if the light has turned off. If the light persists, it may indicate a continuing issue that needs addressing.
The old fuse is for interior lights and radio memory. It does not feed engine management. There should be nothing to reset.
How do you reset the maintenance reminder screen on a nissan micra sve?
Press and hold the mileage reset button turn the ignition on wait for 4 dashes to appear, switch ignition off job done ! this will not work. this only resets your service light and not the engine managent light.
take a battery cable off
You can reset the engine management light Jaguar X type by checking the original Jaguar manufacturer's or owner's manual and making sure that you the reset option is available.
switch ignition to on and press and hold the odometer reset button until the engine lights goes off.
what kind of car is this?
To reset the warning lights on a 2005 Jeep Grand Cherokee, start by turning the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within ten seconds. After that, turn the ignition off and then restart the engine; the warning lights should be reset. If the lights remain on, it may indicate an underlying issue that needs to be addressed.
if you press the rest button in your fuse box inside the car (its most likely under your steering wheel on on the left side of your dash but you have to have the driver door open to access it)
I changed my rediator and the engine light came on and remained on, how do i get this light off
Which lights are you trying to turn off? Check Engine, Service, ABS......
You can reset the check engine light on your Mitsubishi Triton TDI by removing the fuse. Keep the fuse out for 10 seconds and replace it to its original slot.