0
If the low tire pressure warning light is on in your 2008 Chevy Cobalt, here’s how to reset it:
Check and Inflate Tires: Make sure all tires are inflated to the recommended PSI (usually 30-35 PSI). You’ll find the exact pressure on the label inside the driver’s door.
Turn the Ignition to “ON”: Don’t start the engine, just turn the key to the “ON” position.
Press and Hold the TPMS Reset Button: This is usually located beneath the steering column or inside the glove box. Hold it until the tire pressure light blinks three times, then release.
Start the Car and Drive: Drive at 15 mph or more for about 10 minutes to let the system reset.
If the light stays on, a sensor may be damaged or the TPMS module may need replacement.
Need affordable TPMS sensors or other replacement parts for your Cobalt? Visit Used Engine Part your go-to source for quality used auto parts with fast shipping and warranty-backed service. We help you save money and keep your vehicle running smoothly!
What else can I help you with?
How do you reset the traction control light on your 2008 Chevy Cobalt?
Scan tool
How do you reset the engine check light for a 2008 Chevy Cobalt?
Fix the cause of the light coming on and the light will reset itself within a few drive cycles.
Chevy Cobalt tire monitor reset?
2008 Chevy cobalt tpms reset
Where is the fuel reset switch on a 2008 Chevy Cobalt?
There is no fuel reset switch on any model cobalt if i remember u can do that by disconnecting the battery for a couple of minutes.. that will reset the computer
How do you reset the tire pressure warning light on a 2008 dodge Caliber?
The light will reset itself if the system is working properly and the tires are at the correct pressure. If the pressure is correct and the light is still on, you need to take it in for service.
How do I reset tire monitoring on 2008 Cobalt?
To reset the tire pressure monitoring system (TPMS) on a 2008 Chevrolet Cobalt, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "On" position without starting the engine. Press and hold the TPMS reset button, typically located under the dashboard or near the steering wheel, until the TPMS warning light blinks three times. Finally, start the engine and drive for a few minutes to allow the system to recalibrate.
How do you reset the the oil light on the 2008 Chevy Cobalt?
Turn on the key but don't start the car. Push the gas pedal to the floor and release 3 times. It will now reset.
How do you reset the low tire pressure light on a 2008 ford ranger?
buy a chevy
Reset 2008 Toyota Corolla tire pressure light?
To reset the pressure light, first inflate the tires to the proper cold pressure (30-32 lbs, or as the sticker says on the door frame when you open the car door), and then hold the button in for five seconds on the pressure light.
How do you reset low tire air pressure warning light on 2008 trailblazer?
read your owners manual
How do you reset tire pressure sensor on 2008 Nissan Sentra?
manual for reset tire pressure for 2008 nissan sentra
How do you reset to engine light in a 2008 Chevy Cobalt?
To reset the engine light in a 2008 Chevy Cobalt, you can disconnect the battery by removing the negative terminal for about 15 minutes and then reconnecting it. Alternatively, you can use an OBD-II scanner to clear the trouble codes that triggered the light. If the underlying issue is not resolved, the light may turn back on, so it's important to diagnose and fix any problems first. Always ensure the vehicle is off before working on the battery.
