Set the multi-information display to TRIP A.
Turn the ignition switch off.
Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG).
After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
maintenance with engine
disconnect the battery
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
To reset the maintenance required light in a 2007 Toyota, first, turn the ignition switch to the "OFF" position. Then, press and hold the trip meter reset button while turning the ignition to the "ON" position (do not start the engine). Continue holding the button until the maintenance light flashes and then turns off. Release the button, and the light should be reset.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
To reset the 'maintenance required' light on a 2012 Toyota RAV4, start by turning the ignition key to the "ON" position without starting the engine. Press the gas pedal slowly three times within five seconds. Then, turn off the ignition. When you start the car again, the maintenance light should be reset.
To reset the maintenance required light on a 2015 Toyota RAV4, first turn the ignition to the "ON" position without starting the engine. Then, press the gas pedal three times within five seconds. Finally, turn off the ignition and start the engine to ensure the light has been reset.
To reset the maintenance required light on a 2010 Toyota Tacoma, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Turn the ignition off, then start the engine to ensure the light is reset. If the light remains on, repeat the steps.
Your drivers manual should give you the information to reset the oil maintenance light.
To reset the ABS service light on a Toyota Avensis, first ensure the vehicle is turned off. Then, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds; this should reset the ABS light. If the light remains on, it may indicate an underlying issue that requires further diagnosis.
You will need to take it into a mechanic. They will be able to check out your vehicle and then they can turn off the light.
To reset the 'maintenance required' light on a 2007 Toyota RAV4, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, turn the ignition off and then start the engine again; the light should be reset. If the light remains on, repeat the process to ensure it has been properly reset.