You can't. Besides, it's against the law to tamper with the odometer.
Make sure odometer (ODO) is slelected (not trip odometer). Hold in odometer "reset" botton. Turn Igniotion to ON but do not start engine. Light will flash and go off. Turn Ignition OFF. Release "reset" button.
Under the speedometer. Push the trip meter reset button and the display will change from outside temperature to the odometer.
With the engine off and the odometer readout set to miles and not to Trip A or B, push and hold the odometer reset button while at the same time turning the ignition on without starting the engine. After 5 seconds the light will reset.
While in the trip mode, hold button in for a couple of seconds.
I Believe Its Turn Ur Key To Acc Then Set Ur Odometer To Mileage. Turn Off Key Then While Holding Odometer Switch Turn Back To Acc . Itll Blink Then Reset. That's How U Do It On An 05.
Put the key into the ignition and press the odometer button. While holding down the odometer button, turn the key to the on position. You will see "-----"on the odometer display. It will count down "-----" "----" "---" "- -" "-". Then you will see zeros on the odometer display "000000". You can now release the odometer button. This will reset the maintenance light on your dash!!!!!!
Press the odometer reset button while at the same time turning the ignition to the on position without starting the engine. After 5 seconds the light will reset.
# Turn your ignition to the ON position # Press the Odometer reset button until the Trip A is displayed # Turn the ignition to OFF # Press and hold the Odometer # Turn the ignition back to ON # Hold the Odometer reset button until the odometer reads 000000 (it will count down from ------ to ----- to ---- etc) The Maint Reqd light should turn off at this time # Turn the ignition back off # If you want to verify that it worked, just turn the ignition back on This does not work on a 2006 Camry. Instead of Trip A, use the odometer display and follow the rest of the instructions.
Next to the odometer is a button. Press it to switch between odo and trip. While in trip, hold it to reset the tripometer.
-First turn the key to the "ON" position. -Set the Odometer to the true odometer position (not ether of the trip odometers) -Push in and hold the button for the odometer with your left hand. Keep holding it in -Turn the key "OFF" with your right. -Turn the key to the "ON" position again. The odometer should be replaced by five horizontal lines. Keep holding the odometer button down until all the lijnes disappear. The Maint Req is now reset for another 5,000 miles.
To reset the service indicator wrench:Hold down the odometer reset button with the ignition offWait for the trip indicator to show 0's. Then turn the ignition on, but don't start the carLet go of the reset button, and press the M button.
Push and hold the odometer reset button while at the same time turning the ignition switch to the on position (do not start the engine). In about 5 seconds the light will go out and the system will be reset.