You do not reset a battery light. The light is on because there is something wrong with the charging system on the vehicle. In most cases the alternator has failed and needs replacing. Once you fix the problem that caused the light to come on the light will go out.
To reset computer on dodge caliber. remove the dodge caliber, remove the negative and positive cable from the battery. You can then reset your computer.
Reset light when replacing headlight
A scan tool is required.
Dodge does not use inertia/reset switches.
To reset the check engine light on a 2010 Dodge Caliber, you can use an OBD-II scanner to clear the trouble codes. If you don’t have a scanner, you can also disconnect the negative battery terminal for about 10-15 minutes, then reconnect it. This will reset the vehicle’s computer, but be aware that any stored trouble codes will be lost. If the light returns, it’s important to diagnose and address any underlying issues.
Just disconnect the battery and turn the key on for 30 minutes to one hour.
To reset the oil light on a 2010 Dodge Caliber, first turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within ten seconds. After this, turn the ignition off, and then start the engine to check if the oil light has reset. If the light remains on, repeat the process.
Reset a battery? There is no such thing as resetting a battery.
Dodge does not use inertia/reset switches.
To reset the maintenance required light on a 1989 Dodge D50, disconnect the battery. Leave it disconnected for 10 minutes before reconnecting it.
You can reset the check engine light on a 2007 Dodge Dakota by unhooking the battery. Leave it unhooked for 10 minutes before reconnecting it.
Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.