Disconnect negative battery cable for 5 minutes. This may or may not reset the light. If not you will need an OBD 2 scan tool. Know that if you do not repair the problem that caused the light to come on it will just come back on.
how do i reset the check engine light on a 1999 acura 3.2tl
check engine light reset on a 1999 Acura CL 3.0.. Just replaced the egr valve. Thx
with a scan tool
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
u do a poo
Disconnect the Battery for 5 minutes
After repairing the cause of the code, you reset it with a scan tool.
take it to your mechanic so he can run a diagnostic.
remove the alternator fuse for 20 seconds.
Have vehicle scanned to determine problem and have codes cleared
Remove the negative battery terminal for three minutes.
Have vehicle scanned to determine the problem and/or have codes cleared