answersLogoWhite

0

You can reset all systems by unpluging the battery coneections for a few minutes. I would suggest doing this any time you have an engine light or warning light come on as sensors are sensitive. If the light comes back on take it in for service.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

2003 Mazda tribute why does the airbag like stay on?

The airbag light on a 2003 Mazda Tribute will stay on if a defect is detected in the system. This can include the sensor or the airbag itself which should be immediately repaired.


On a mazda tribute what does the car with a key light indicator mean?

On a Mazda tribute, the car with a key light indicator means that the engine is started.


Oil light flashing in Mazda tribute 2001?

If the oil light is flashing in your 2001 Mazda Tribute, it typically indicates low oil pressure or that the engine oil level is low. It's essential to check the oil level using the dipstick and add oil if necessary. If the oil level is adequate, the issue may be due to a faulty oil pressure sensor or pump. In either case, it's advisable to address the issue promptly to avoid potential engine damage.


Check engine light Mazda Tribute?

The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.


2003 Mazda tribute daytime running lights relay where is it located?

Where is the module light day on Mazda tribute 2003 4 cylindre


Engine light on a 2001 Mazda Tribute?

After correcting what the initial problem that caused the light to come on, I was able to disconnect the negative terminal of the battery for about 1-2 minutes and the light went away. I hope this helps... "01" Mazda Tribute 3.0L V6


Are airbag light problems common on a 2002 Mazda Tribute?

This airbag issue is part of a recall by Mazda. You should contact your dealer.


Dash gear indicator light stays on?

Short in dash cluster is common on mazda tribute


Mazda tribute engine light?

When the check engine light comes on, it's a good indication that something is wrong with your engine.


What is the gazebo looking dashboard warning light on a 2003 Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car?

"What is the gazebo looking dashboard warning light on a 2003 Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car Mazda tribute and why does it stay on for a minute before shutting off when you initially start the car?"


I have a 2001 Mazda Tribute. Why would my engine coolant light stay on and the fluid is not low It goes off then it will come back on. Any suggestions?

Our Tribute is doing the same. Anyone help? It can be the sensor or have the cap checked out. The caps in these go bad. You can replace the cap/container (sold as one unit), or try putting in approximately 1 qt of coolant above the full line (sometimes this works). the floating ball sinks and the sensor goes on to make the light come on there ios a recall for this bring it to your Mazda dealer


How do you reset the Tire Pressure Sensor Default light on a 2009 Ford Focus?

hi how do i reset tire pressure sensor light on