0
To reset the service light on a Discovery 3 TDV6, first, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal fully three times within ten seconds. After that, turn the ignition off and then back on. The service light should now be reset.
What else can I help you with?
Related Questions
What mileage does the camshaft drive belt of a Discovery 3 TDV6 first need changing?
every 18 000 miles
Where is the oil filter range rover sport tdv6?
under the car in front of fuel tank 2007 on .
Engine size of range rover sports 2008?
TDV6 2.7L, V8 NA 4.4L, V8 4.2L supercharged, TDV8 3.6L twin turbo.
Trending Questions
How do you tune up a 2000 Saturn SL2?
How do you replace egr valve 2000 eclipse gt?
How do you install a serpentine belt on a 1990 Lincoln Continental?
Fusible link on plymouth voyager?
Where is the fuel injector regulator tbi in a 1991 cchevrolet van g20 5.7l ?
Who makes the tires for silver cross prams and can you buy replacement tires?
What is the stock gear ratio?
What size in inches is a 235 70 16 tire?
Where is the battery located in the BMW 325xi?
Can I use just the gas that has separated from its ethanol in my lawn mower?
What TYPE of antifreeze does a 1993 Geo Metro use?
What is voltage on lawn tractor battery?
How do you change a PCV valve on 2005 silverado?
Where is the thermostat and how do you replace it?
Whats the gap above the lip?
What does a drive end shield do on a alternator?
What is the difference between a wholesaler and a reseller?
Where is the heat sensor located on a 2003 Pontiac Grand Prix 3.8 engine located?
How much does it cost to mount and balance a tire?
How much will it cost to repair the front transmission seal on a 2003 Hyundia XG350?
Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.