One way. They make a small power supply that has a 9 volt battery that you plug into your lighter socket. It's avaible at most parts store.
Disconnect the negative battery cable from the battery.
Disconnect the negative battery terminal for about 10 minuets.
Disconnect the negative battery cable from the battery, remove the two bolts from the starter, drop the starter enough to disconnect the wires from it and remove the starter from the engine.
disconnect battery
To install a battery cable in a Chevy Blazer, first disconnect the negative terminal from the battery to prevent any electrical shorts. Remove the old cable by loosening the terminal bolts and freeing it from the battery and starter. Next, attach the new battery cable by connecting it to the battery's positive terminal first, followed by the negative terminal. Ensure all connections are tight and secure before reinstalling any covers or components.
disconnect the 91 blazer cables at the battery. One at a time, disconnect the cable at the opposite end, then pull it out. Put the new cable in, routing it the same way, then connect the non battery end. do the same for the other cable, then connect the cables to the battery.
There is no reset for the computer. You can disconnect the negative battery cable for 5 minutes and this may or may not reset any fault codes. If not they will have to be reset with an OBD2 scan tool.
Disconnect the battery cable. Remove the bolts that hold the starter in place. Disconnect the wires. Instahlation is in reverse.
To replace the horn in a 2000 Chevrolet Blazer, first disconnect the negative battery cable to avoid any electrical issues. Locate the horn, which is typically found behind the front grille or near the front bumper. Remove the mounting bolts or screws, disconnect the wiring harness, and then install the new horn by reversing the process. Finally, reconnect the battery and test the new horn to ensure it functions properly.
First, disconnect the negative cable on the battery. Remove bolts support the starter. Lower and tilt starter to give you access to the wires. Detach the wires. Install starter in the opposite method of removing.
5/16" or 8mm
To disconnect the alarm on a 2000 Chevy Blazer, you can start by locating the alarm fuse in the fuse box and removing it. Alternatively, you can disconnect the battery by removing the negative terminal to disable the alarm temporarily. If the alarm continues to activate, you may need to locate and unplug the alarm module, typically found near the steering column or under the dashboard. Always refer to your vehicle's manual for specific instructions related to your model.