0
What else can I help you with?
Related Questions
Can the qg15 ecu drives the qg18 engine?
yes it can but u wont get the power u want becuz the vvt wont connect
How do you set valve clearance intake and exust qg 15?
To set the valve clearance for a QG15 engine, first, ensure the engine is cold. Rotate the crankshaft to align the timing marks to the top dead center (TDC) for the first cylinder. Using a feeler gauge, measure the gap between the rocker arm and the valve stem, and adjust the clearance by loosening the lock nut and turning the adjusting screw until the desired clearance is achieved. Repeat this process for both the intake and exhaust valves, following the manufacturer’s specifications for the correct clearance values.
Trending Questions
How do you repair an evaporative emission control system leak?
1995 Ford Ranger cylinder engine The heater is not working No coolant is leaking AC does work The engine is not overheating What could be wrong?
Where you can get replacement seat covers and foam to rebuild your 87 suzuki samurai with split seats in the rear?
High level of engine oil what type of smoke?
Timing firing order for 1985 Oldsmobile Delta 88?
What is recommended tire pressure for 2003 4 runner?
93 ford mercury topaz that makes one click when try to start it but won't turn over yesturday it worked fine Starter was just replaced 2 weeks ago battery is fully charged any ideas?
What does the A and B mean on a muffler?
What US city had the first NTB Tires store?
Where is the drain plug for the gas tank in a 1992 Toyota Corolla?
What is the national animal of China?
Does the Renault master 2.5 dci engine have a timing belt?
Who sells Winston winner tires?
What bulb replaces Polaris part number 4030059 cross reference?
Where is the fuel pump relay on 04 VW Passat?
Does a PT Cruiser have a vent on the transmission for over filling?
What is meaning of 10w30 oil?
Can 85w-140 gear oil be used in place of 75w-90?
Does an alternator squeal when going bad?
Why does my clutch pedal on my 1997 Chevy S-10 go all the way to the floor when pressed Does it need adjustment If so how do I do that?
Copyright ©2026 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.