Connect timing light to #1 spark plug and battery
Remove and plug vacuum line to vacuum advance unit on distributor
Mark appropriate timing mark on crankshaft and stationary reference
Loosen distributor cap slightly
Start vehicle and aim timing light at timing marks
Rotate distributor to align marks
Tighten distributor cap when marks are aligned
Reconnect vacuum line
How do you set timing on a 1995 Cadillac Deville
how do i set the timing on a 1998 cadillac deville 4.6
how do i set my timeing on a 1992 cadillac v8 4.9 liter
18 Degrees Before top dead center *Engine warm *Set at 1400 RPM *Distributor vacuum hose disconnected & plugged *Transmission in drive (parking brake engaged) *All accessories off.
To set the timing on a 1990 Cadillac Seville 4.5 liter, first ensure the engine is at operating temperature and turned off. Locate the timing marks on the harmonic balancer and the timing cover. Use a timing light to check the current timing, then loosen the distributor hold-down bolt and adjust the distributor to align the marks to the specified timing setting, typically around 10 degrees BTDC. Finally, retighten the distributor bolt and recheck the timing to ensure accuracy.
Look up a Cadillac maintenance book. Check location of ALDL terminal socket, make a jumper wire, jumper the listed terminals. Attach your timing light, and start your engine. You will be able to see, the markings on the crank shaft pulley, against the marks on the engine. Check your timing that is listed under the hood. You can adjust the timing by loosening the lock nut under the distributor special wrench needed. ALDL assembly line diagnostic link, usually located under dash. You can also check timing with a code reader with live data reading.
Under the rear passenger set. It is a sealed special battery that cost about $130+ and has a special vent to take fumes out of the cabin.
you do not need a lift, just a set of low profile tires 245 30 22.
did the parking brake get set, or the shoes adjusted too tight?
using a tach , idle adjustment on R/S of carb ( drivers side when standing in front of car ) adjust idle in PARK , A/C off
disconnect vacumn advance hose, bring down to curb idle, connect timing light to the # 1 spark plug wire, loosen distibutor and adjust as necessary
To time a 1993 Cadillac Brougham with a 5.7-liter TBI engine, first, ensure the engine is at operating temperature. Disconnect the timing connector (usually a tan wire with a black stripe) to set the timing control to the base timing mode. Use a timing light to check the timing marks on the harmonic balancer, adjusting the distributor as necessary to achieve the specified timing of 0 degrees BTDC. After adjustment, reconnect the timing connector and recheck the timing to ensure it remains correct.