look at ignition control module cable that have green color pull straight up you see inside look like coaxial cable . to test it you must have multifunction volt meter by turning on ohms by placing positive lead to inside and negative to outside you will getabout 650 ohms.
crank position sensor is between oil filter and starter, follow wire from module
The oxygen sensor for my 1989 190E 2.6 is located on top of the exhaust just underneath the passenger side of the car. The wiring from the 02 sensor runs up underneath the passenger side floorboard carpet.
A Mercedes 190e doesn't have a carburetor. They are fuel injected.
oil filter on a Mercedes 190E 1986 is in the back of engine
== ==
Located just behind the front license plate. Looks like a little pencil.
unplug the connector, remove the oxygen sensor, it is located under the vehicle at the catalytic converter. install new oxygen sensor, plug in connector. done.
No they will not.
Put the key in the #2 position and put it in neutral, there is a safety in the rear wheels if you don't have the key in the #2 position that will lock the brakes. I had the same problem.
A Mercedes-Benz 190e has a curb weight of approximately 3000 pounds. This varies by the year and configuration of the vehicle.
10'5"
There is no filter:)