Change the blinker bulb for that side. It is a hit and miss though. If you change the front bulbs and it still doesn't blink you will also need to change the rear bulbs. The front bulbs are rather difficult to change from above the vehicle. You may want to get underneath and definitely during the day!!! THE REAL ANSWER!!!!!! This drove me crazy on my daughters car. It turned out to be the day time running light modual wich is located behind the radio. the conections were loose. when you turn on the right turn directional the front light would go out but the rear directional would work. listen closley behind the radio for a one click noise when you activate the right turn, and also a delay one click when you deactivate.
HOW DO YOU GET THE LEFT TURN SIGNAL BULB OUT ON A 2000 PONTAIC FIREBIRD
its underneath the steering wheel... you just need to remove the cover and its right there
RIGHT OF STEERING COLUMN, MOUNTED TO BOTTOM OF INSTRUMENT PANEL CARRIER.
Located right of steering column, mounted to bottom of instrument panel carrier.
under and to the right of the steering wheel column, behind the panel that can be removed...closest to your right knee while driving.
raise the hatch pull down on the carpet, determine which light is out and twist to come out, you dont replace from the outside of the car!!!
How to change blinker switch in a 1994 Firebird ?
www.autozone.com has online manuals if turn your blinker on you should be able to find them by listening for the click click click under the dash
On a 1997 Pontiac Firebird, the high beam switch is typically located on the left side of the steering column. It is integrated into the turn signal lever; pulling the lever towards you activates the high beams, while pushing it away returns to low beams. If you're looking for a specific feature, consult the vehicle's owner manual for detailed instructions.
In a 1967 Pontiac Firebird, the turn signal flasher is typically located under the dashboard, near the steering column. It can often be found attached to the fuse panel or mounted on a bracket near the ignition switch. To access it, you may need to remove the lower dash panel for better visibility. Always refer to a service manual for specific guidance related to your vehicle.
how do you remove the turn signal assembly on a 1989 Pontiac Bonneville
In a 1989 Pontiac Bonneville, the flash signal, which activates the turn signals and hazard lights, is typically found in the steering column. It is controlled by a turn signal switch that is mounted on the column. If you're looking to troubleshoot or replace it, you may need to access the steering column assembly to reach the switch and associated wiring. Always ensure the vehicle is turned off and properly secured before working on electrical components.