0
Need a code reader that can plug into car's diag port (OBD1) preferably after repair or it will come on again. Find out why the light is on-it could be serious or get expensive if you ignore. You may also be able to reset by disconnecting batt for 30 mins, but will only be temporary.
What else can I help you with?
Where do you look when the check engine light on a 1994 Mercury Villager comes on?
dash dash
98 Mercury Villager check engine light?
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
How do you get the check engine light off in 1997 mercury villager van?
By bringing it to a trained mechanic so they can check the engine is running properly (which if the light is on it's probably not)
How to troubleshoot a check engine light on a 1998 Mercury Villager?
Have vehicle scanned to determine the problem
1996 Mercury Villager the check engine light comes on and off?
have vehicle scanned to determine problem
How do you reset check engine light on a 1994 mercury villager?
The easiest way is to unhook the battery for a minute.
How do you reset the check engine light on a 2000 mercury villager?
You either need a scan tool, or unhook the battery for a minute.
1993 mercury villager runs rough when check engine light comes on codes 34 51?
If the 1993 Mercury Villager runs rough when the check engine light comes on and the code reader says 34 and 51, there is a problem with an oxygen sensor and the MAP (Manifold Absolute Pressure) sensor. Both parts together will cost around $200.
How do you reset the 'service engine soon' light on a 1999 Mercury Villager?
With an OBD2 scanner.
What can cause the Check engine light on a 2001 mercury villager to stay on?
There are many, many things that can cause the MIL to light up. You will need to have the problem diagnosed by first reading the codes and going from there.
How do you reset a check engine light on a 2001 mercury villager?
take it to auto zone and ask them to check and then clear the codes or remove the positive battery cable and press the brake pedal for 30 seconds.
How do you tell if the computer is bad in a 1996 mercury villager?
IF the computer was really defective, either the car would not run, or there would be a check engine light due to a fault code.
