0
To use the Steel-Mate car alarm remote 898, first ensure the alarm system is properly installed in your vehicle. To arm the system, press the lock button on the remote; you'll hear a confirmation sound. To disarm, press the unlock button. Additionally, you can use the panic button for emergency situations or to locate your vehicle.
What else can I help you with?
How do you program your car alarm remote to your car?
You can set your alarm to your car using the remote control exclusively for cars.
How do you sync a Nissan Maxima 2005 car alarm remote?
my alarm remote does not honk wen locked
How do you program a python 488p car alarm?
488P Is the remote to a Python car alarm, need to be more specific on the alarm you have.
Can you have a car alarm without remote keyless entry?
Yes, you can have a car alarm without remote keyless entry. You can read more at www.ecarsecurity.com or www.autotechs.com
Where was the car alarm remote invented?
The car alarm was invented as far back as the early 1920s. These remotes were crude by today's standards. The car alarm remote did not achieve popularity and wide spread use until much later.
Reprogram car alarm remote?
Press reset?
How do you reset a car alarm remote?
no body knows
How do you turn the alarm off inside the car without a remote for 2001 Nissan Maxima?
How do you turn the alarm off inside the car without a remote for 2001 Nissan maxima
How do you stop a car alarm with just the key to the car?
Click the button on the remote
How do you reset your 1997 Chrysler lhs alarm?
Unlock the car with the remote or the key in the door.Unlock the car with the remote or the key in the door.
How do you disarm the alarm on a 1994 Chrysler LeBaron?
Unlock the car with the remote or with the key in the door.Unlock the car with the remote or with the key in the door.
How do you program a steel mate car alarm remote?
This is the methode I had used to change my remote on my Steelmate twoway pager alarm( 838).It should have a learning code button or pinhole(in this case you have to insert a small pin into the hole) on the main controller unitThis is the procedure1 )Press learning code button/hole for 10 seconds,this will cancel the current remote.2) Press the learning button for another 2 seconds,then the lead light will turn on .3) Press the locking button of the remotes within 10 seconds .This will programme the new remote.Please post your results
