Unless you are an electrician, I would not attempt it, you will need a special tool do wrap it around the axle (The post in which the voice coil moves up and down on). Either have a tech do it for you, or replace the speaker.
you don't light the car on fire and make it explode
a speaker uses a voice coil a coil copper wire and a magnet and pole to vibrate a cone
The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.
yes coil is a type of wire
AnswerDual Voice Coil in regards to subwoofers means there is 2 positives and 2 negatives. Its just used to wire up different ohm levels. Like if u have a subwoofer that are dual voice coil @ 4 ohms then u can parallel or series wire it to become Single Voice Coil @ 2 ohms. Google the word Series Wiring or Parallel Wiring for examplesAlso this type of speaker is one of the few that can be connected to 2 different amplifiers at the same time and still work properly. One coil is connected to the car stereo and the other coil is connecter to my scanner.
The coil wire.
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.
Toyota Camry coil wire can burn out from age or excessive use. The manufacturer recommends that you change the coil wire every 30,000 miles.
electric current in the coil of wire.
These are single voice coil. All JL Audio woofers are single voice coil except W6 and the 13w7.
If you see no center coil wire connector then the coil is mounted inside the distributor. If there is a center coil wire connecter then follow the coil wire and it will go to the coil.