answersLogoWhite

0

There's continuous power supplied to the circuit. When the switch contacts, it closes the circuit and allows the power to go to the brake lights.

User Avatar

Wiki User

∙ 12y ago
User Avatar

What else can I help you with?

Related Questions

Why your cruise control don't work on a 1998 peterbilt?

Bad switch, bad wiring, ECM fault. If your jake brakes still work, you can rule out the accelerator position switch. The brake position switch might be reading that the brake is depressed when it isn't.


1985 bronco brake lights dont work but all other lights do work you replaced brake light switch and bulbs?

Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.


Where is brake light switch on 92 Lumina Z34?

Above the brake pedal. If your main brake lights dont work but your third center brake light does, then the brake light switch is not the problem. Its is the turn signal switch.


How do 1996 gmc Yukon brake lights work?

The 1996 GMC Yukon brake lights work by receiving power from the brake light relay switch. The brake light relay switch is connected to the brake pedal.


Brake light and cruise don't work on Chevy Avalanche?

Check the brake light switch on the brake pedal


Why the brake light stays on with out keys?

The brake lights work without the key on, so you have a problem with your brake light switch.


Why don't the brake lights work but the flashers and running lights work if the bulbs and fuses are good?

Please check the Brake light switch....The brake light switch should be located near or on the brake pedal (up on the stem of the brake pedal)


How do you make your 1990 jeep wrangler brake lights work even after replacing the brake light switch?

Your fuse could be blown, or the brake light switch is improperly adjusted.


Why wont brake lights work on 1996 ford escort fuse and bulbs have been replaced?

check the wires at brake light switch on brake pedal they are bad about breaking brake light switch


Brake lights don't work when the brake is pushed. Work with headlights on only.?

The brake lights and the tail lights are separate circuits. Check the brake light fuse, then check the brake light bulbs, then check the brake light switch.


Why don't brake lights work on 92 s-10 but other lights do?

Check the brake light fuse, the bulbs, the brake light switch and last, check the signal switch.


Brake light won't work on 1986 Chevy caprice classic?

Check the brake light switch on the brake pedal. Might have to replace it.

Trending Questions
What is the torque spec for a Chevy small block intake manifold? How do you change the fuel filter in a 1995 T100? 3.8 L No codes run's rough rpm's fluctuate between 670-820 Plugswires new Replaced the Crankshaft sensor but still same issue If placed in Drivereverse and let go the break car dies Starts up again? How do you replace rear shocks on a 1987 Rolls-Royce corniche 2 door? Is timing chain part of internal engine system? My Holden rodeo turbo diesel is using oil you had new rings and a new turbo but still uses oil would it be the valve stem seals? How do you change brakes on a 2004 Ford Expedition? Is it ok to put unleaded gas in diesel tank? Where do you check the transmission fluid in a 1998 ford explorer with a manual transmission? What gear ratio came in a 2003 s10? Where is the crank sensor located on a 2004 Yukon Denali? Why does your 98 lumina wont turn over not even a sound already check the battery starter and alternator door lock is not even working and all its electrical components? Who kicks off after a team scores 2 points after a blocked extra kick return? Why does oil smell? What is Bannedstory and How do you download it? What type of antifreeze does a 2000 dodge caravan use? 2000 ford e150 fuse diagram? Where is the speed sensor on a 2004 Lincoln ls? Where is the fuse box on a 1980 Corvette? Your 1999 qx4 sways and rocks at about 60 mph The left rear sway bar link was stripped so you had it replaced but the unstableness has not stopped?