Pulling the fuse and/or relay does not work. Still troubleshooting to figure out. Will post when known.
Disconnect horns, disconnect battery, disconnect relay, disconnect fuse .........................................or repair problem.
On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.
It does no harm to disconnect the battery when working on a vehicle but in general no, you do not need to disconnect them to change a filter.
Follow the wiring harness from your blinker. Disconnect the factory harness from the relay. Replace with the new relay.
how the apfc relay work
The starter relay on a 1995 Buick Le Sabre is typically located in the under-hood fuse and relay box. This box is situated near the battery on the driver's side of the engine compartment. You can identify the starter relay by checking the diagram on the inside of the fuse box cover for the specific relay location. Be sure to disconnect the battery before attempting any work on the relay.
There are numerous applications for a normally-closed relay contact. It is used whenever you want to disconnect a circuit when the relay coil is energised.
there is no starter relay have your car alarm checked it has a starter disconnect that goes bad
you can remove the horn relay in the fuse box.
the only place I felt on the clock is the small relay type switch that was buzzing which I prsume is the buzzer. but I do not know how to disconnect. thought of breaking solder on on terminal but do not know if relay work with some other part of the clocks.
Not usually. Disconnect it and see what happens.