0
The rear bumper cover is fastened to the car in exactly 9 places. Follow this procedure:
- Raise the trunk lid
- Remove the three push-in fasteners in the center of the top of the bumper, directly underneath where the license plate holder would be when the trunk lid is closed
- Jack up the car and remove the driver's rear wheel << you don't *have* to do this. You *can* do the rest without doing this, but your life will be easier if you do. Trust me.
- On the driver's side, at the bottom rear of the rear wheel well, remove the two screws that attach the bumper cover to the rear fender
- Peel back the wheel well liner (very stiff piece of black plastic). Remove the hidden screw attaching the bumper cover to the fender. This screw is approx 2 inches from the forward edge of the bumper cover.
- Repeat for the passenger side
- Bumper cover should simply fall off.
What else can I help you with?
2008 rear bumper Chrysler Sebring how to take it off?
To remove the rear bumper from a 2008 Chrysler Sebring, start by disconnecting the negative battery cable for safety. Then, remove any screws or bolts securing the bumper, which are typically located under the rear lights and along the underside of the bumper. Carefully detach the clips or fasteners holding the bumper in place, and gently pull the bumper away from the vehicle. Finally, disconnect any electrical connectors for rear lights if applicable before fully removing the bumper.
How do you remove remove rear bumper Chrysler sebring 2004 touring?
To remove the rear bumper from a 2004 Chrysler Sebring Touring, start by opening the trunk and removing any screws or clips securing the bumper to the body. Next, detach the tail lights by removing the screws and gently pulling them out. Then, locate the bolts underneath the bumper and on the sides, typically near the wheel wells, and remove them. Finally, carefully pull the bumper away from the vehicle, ensuring any remaining clips are released.
How do you remove the rear speakers on a 1999 Chrysler sebring lxi coupe?
from the inside of trunk
Where is the hydraulic motor in a 1999 Chrysler Sebring convertible?
It is behind the rear seat. You remove the rear seat to access.
Where is the hydraulic pump for a 1996 Chrysler sebring convertible?
It is between the rear seat back and the trunk. You have to remove the rear seat to access.
Where is the convertible top motor located in a 2002 Chrysler Sebring?
It is behind the rear seat. You have to remove the seat to access.
Front license plate mounting Chrysler Sebring convertible?
There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
How do you remove the passat rear bumper?
how to remove 2013 passat rear bumper
Do you put cable chains on rear tires of a Chrysler Sebring convertible?
No, the front. A Chrysler Sebring is front wheel drive.
Is there a drain plug for the radiator on a 2001 Chrysler sebring?
Should be on the bottom or rear of the radiator or remove the lower radiator hose
Does a 2004 Chrysler Sebring have rear ball joints?
Yes
How do you remove rear bumper from 1999 Ford Taurus?
Remove rear bumper on 99 ford tarrus
