Park the vehicle on a level surface, drain the oil, & change the filter. Pour in 4 quarts of the correct weight oil, and start the engine. Let it run for 2 minutes and then shut off. Wait 30 minutes and then check the oil lever. Add as necessary to reach the full mark. You now know the capacity.
For a Vauxhall Astra with a 1.8-liter engine, you typically need to fill it with approximately 4 to 4.5 liters of oil after an oil change. It's important to check the owner's manual for the exact specification, as variations can exist based on the model year and engine type. Always ensure to check the oil level with the dipstick after filling and running the engine briefly, adding more oil if necessary.
It will be fine.
To fill the gearbox oil on a 1998 Opel Astra 200i Euro, first ensure the vehicle is on a level surface and the engine is off. Locate the gearbox fill plug, which is typically on the side of the transmission. Remove the plug and use a funnel to pour the appropriate gearbox oil until it reaches the fill level, which is usually just below the fill hole. Reinstall the plug securely after filling.
To pour gear oil into the gearbox of an Opel Astra 180 with an Ecotec engine, first ensure the vehicle is on a level surface and securely lifted if needed. Locate the gearbox fill plug, typically found on the side of the transmission. Remove the fill plug using the appropriate tool, then use a funnel or pump to pour the gear oil into the fill hole until it reaches the recommended level. Replace the fill plug securely after pouring.
To fill a 1994 Subaru Impreza, the engine typically requires about 4.5 to 5.0 quarts of oil, depending on the specific engine type. This translates to approximately 4.3 to 4.7 liters. Always refer to the owner’s manual for the exact capacity and recommendations for oil type.
takes 4.5-5 liters to fill up when doing an oil change
It will fill a large bathtub.
72 liters is 72,000cc
12
2.8 liters to fill and 6.2 liters to fill when you've done a flush ( includes torque )
About 200 litres to fill a bath.
about ten or eleven liters -Never put a dry converter into a transmission, fill it 1/2 full of fluid, about 3 to 4 litres or quarts, then once the transmission is in, put 4 liters in, run the engine and this will fill the converter fully. With engine running, fill to the "warm" position on the dipstick, take the car for a 10 minute drive and top up the level (with engine running) to the "hot" mark.