0
What else can I help you with?
Where is the brake switch on 2002 Ford Mustang?
brake light switch is above the brake pedal
Brake lights stay on 2002 mountaineer?
check the brake light switch
2002 ford explorer brake lights stay on all the time?
check brake light fuse and brake light switch on pedal
Where is the brake light switch on a 2002 Chrysler sebring?
On a bracket, above the brake pedal.
Where is the brake light switch on a 2002 Chrysler 300m?
It is on a bracket just above the brake pedal.
The brake light wont go off on 2002 Pontiac aztek?
Might be a stuck brake light switch its located at the top of the brake pedal
Where is the brake light switch on a 2002 Chevrolet Malibu?
It is on a bracket under the dash and above the brake pedal.
2002 Mercedes Benz CL500 15200 miles Question- Car starts foot brake engaged automatic gear shift lever locked won't budge?
The most likely cause is the brake light switch has failed check if the brake lights are working.
What causes brake light failure in a 2002 astro while turn signals still work?
There might be a switch attached to the brake pedal. When depressing the brake, at a certain point in the travel of that pedal, it trips a switch, which turns on the brake lights. Have someone check to see if the high mount brake light is or is not coming on, too. Chances are it is that brake light switch.
Where is the brake light sensor in a 2002 dodge neon and how do I fix it?
There is no brake light sensor. There is however a brake light switch. It may be mechanical, which would be located somewhere on the brake pedal lever. It can be bad or just out of adjustment. It can also be a pressure switch located on the master cylinder.
2002 Mercury Villager brake light lights up on rough roads.?
Brake light switch needs adjusting or replacing. It is too sensitive.
How do you replace the brake light switch on a 2002 Jaguar XJ8?
To replace the brake light switch on a 2002 Jaguar XJ8, first, disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted near the top of the brake pedal assembly. Remove the electrical connector from the switch, then unfasten and remove the old switch. Install the new switch by reversing the steps: secure it in place, reconnect the electrical connector, and finally reconnect the battery terminal.
