0
How much can i expect to pay and what all do i need if i want basic turbo in my car i know you need at least injectors fueloil lines etc also i want a turbo timer?
really depends on the car and the space available . if you are going to run 5-10 psi then it might be good on the engine you already have but any thing over 10 you would need a forged engine ( pistons and rods ) to make it strong enough turbo - 500 - 1 K conversion with flanges etc - 1000 fitting 1000, 1500 ecu & fitting 2000 so all up other including the above you are looking at a minimum of 5000 for a turbo setup.
What else can I help you with?
Do you have to replace all fuel injectors if only two are bad on a 1996 dodge stratus?
If two injectors have failed it is more than likely that the other injectors could fail. I would replace all the injectors, or at least inspect them for possible failure
How much is lasik eye surgery?
The cost of LASIK surgery will vary based on the laser used, the extent of eye repair needed and the practitioner. Expect a minimum of $1,500 for a basic laser that is not "wavefront" guided. With wavefront, expect at least $2,100.
What is the least basic nitrogen atom in purine?
The least basic nitrogen atom in purine is the N9 atom.
Whichof these would you expect to have the least momentum?
An object with the least mass and velocity would have the least momentum.
How much to sell a used mini motorcycle?
Depends on how rare it is. If it's you basic outlet bike, don't expect much.
Where is the code entry page in heartgold?
where you least expect it! ;)
What are the release dates for The Hills - 2006 When You Least Expect It 2-2?
The Hills - 2006 When You Least Expect It 2-2 was released on: USA: 22 January 2007
How do you change diesel injector in 2004 2.9 ls kia sedona?
the problem is that injectors are forced into head . since head is aluminum and injector is steel after few years they become stucked together as they are one piece . you may expect that at least one injector will be broken during extraction . if you have spare/new injectors best way is to unscrew upper part of injector and chip the rest out with adequate tool . also if injectors are succesfuly removed there is problem with sealing new ones because during removal head will be almost certanly damaged . strongly recomending replacing whole head with injectors . used one in good condition is much cheaper than set of new injectors and head repair . This is absolute nonsense, make a injector puller sliding hammer type and loosen holding clamp and wiring then pull hard upwards and the injectors will come out.
Where Headlight relay on Ford Falcon EF?
Where you least expect it.
Where would you least expect an earthquake to occur?
Certainly not haiti!
How can i slap someone?
how to snap on a person
What you expect to have the least momentum?
a small mass moving slowly
