the mitsibushi fto engine holds 6.5 litres of coolent.
What?! Until full! Start the vhicle, run for 10 inutes to enable the thermostat to open and the coolant to flow. Add the proper mix of coolant to fill the radiator to the bottom of the neck. The system will be sufficienty full
Pour the coolant in the radiator it self through the silver looking cap. Be sure engine is completely cooled and if not you are able to fill it using the overflow reservoir which is located near the battery.
The amount of coolant to fill a Regal radiator depends on the engine size. A smaller motor might only use 1.75 gallons of coolant, while a larger motor could use 3 gallons.
fill up the radiator and then fill up the over flow located on the pass. side of the truck half way
fill the radiator to the top with 50/50 water and antafrezz
Coolant for Suzuki scrum radiator costs approximately $107.50.
it depends on the size and application of the radiator
It might cost as much as 600 dollars to replace the radiator in your Mitsubishi Lancer. This cost varies with the type of radiator that you choose and with your location.
Fill it till all the cooling veins are covered with antifreeze and distilled water depending on you environment.
You just bough it and are changing the radiator....Radiotor liquid according to its instruction....and fill the radiator up....it had an over flow tank...
The amount of coolant it will take to fill your vehicle is dependent upon how low the coolant level is. You can add coolant to your coolant reservoir. The reservoir will have an indicator of when the coolant system is full.
it depends on the size of your radiator. Just fill it with the correct coolant and top off as the thermostat opens. This assumes the engine is cold (sitting overnight) when you start the engine. Run the heater at max while you do this to bleed the system. Once you can no more coolant to the radiator or overflow bottle, cap the system and make sure the over flow bottle is topped up.