answersLogoWhite

0

Just a short burst at pressure. It is not so much the volume but the pressure I look for. Fuel pumps are the #1 problem on these models.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Should you open the pressure relief valve when you flush the water heater?

Yes, you should, it helps air get in to flush more quickly.


What is the maximum oil pressure you should have in a diesel engine?

High oil pressure is not usually a problem. The relief will open around 100psi on most engines.


How effective is mineral oil for relieving constipation?

Mineral oil can be effective for relieving constipation by lubricating the intestines and softening stool. However, it should be used with caution as long-term use can lead to potential side effects such as nutrient malabsorption. It is recommended to consult with a healthcare provider before using mineral oil for constipation relief.


What will cause a marine air compressor high pressure relief valve to lift?

Excessive pressure in the compressor, after the first stage (or how ever many stages there are). Excessive pressure could be caused by shut/ blocked discharge valve. There will also be a relief valve fitted to the intercooler, should one of the tubes burst. This would let air into the water side and suddenly increase the pressure in the intercooler, so a relief valve is fitted.


Should a Pressure Relief Valve be installed on a boiler hot water system?

Yes ( always ) and make sure it is rated for the B.T.U.


Why has your slow cooker got a rubber stopper in the hole on the lid?

The main pressure relief valve in the center allows steam to escape once the pressure reaches a maximum volume. Should that relief valve be blocked with food particles the rubber safety valve has a slightly higher pressure tolerance and will pop off releasing pressure as a failsafe.


Is my hot water heater pressure relief valve leaking?

To determine if your hot water heater pressure relief valve is leaking, check for any water dripping or pooling around the valve. If you notice water, it may indicate a leak and you should have it inspected by a professional.


Is it normal for water to leak out of the pressure relief valve on a hot water tank?

YES, as a hot water tank should NOT have a relief valve it should have a combination of Temperature and Pressure relief valve. Normally a T&P is SET @150 PSI and Or 210 Deg F. If the valve leaks this is a sign of an impending disaster such as a pressure vessel exploding. A professional will check to make sure (NBBI, ASME, LMP,) 1- The pressure is not exceeding the high limits of the system 2- Make sure the aqua stat is actually functioning 3- The pressure temperature relationship of the system is not exceeded


Why is my water heater overflowing and what should I do to address this issue?

Your water heater may be overflowing due to a buildup of pressure or a faulty pressure relief valve. To address this issue, you should first turn off the power or gas supply to the water heater. Next, try releasing some of the pressure by opening the pressure relief valve. If the problem persists, you may need to contact a professional plumber to inspect and repair the water heater.


When installing the new liquid propane gas cylinder the pressure relief valve should point?

When installing a new liquid propane gas cylinder, the pressure relief valve should point away from any ignition sources, buildings, or high-traffic areas. It should be positioned in a safe direction where any released gas will not cause harm or damage.


What are the health advantages offered by the juniper berries?

Juniper berries have a number of health benefits, these include aiding digestion, relieving minor stomach cramps as well as the relief of gas and flatulence. Juniper berries may impair the absorption of iron so you should consult a physician should this be a concern.


Where should the relief valve on oil mount for small block Chevy be located?

The pressure by pass is located on the adapter that you screw the oil filter to.