0
Approximately 5 quarts, including the capacity of the oil filter, is required for the 350 ci motor. If the motor is the 454 ci unit, then an 6 quarts will suffice. The best way to determine the proper level is to start with the numbers shown here, fill the motor, allow it to run for several minutes, then re-check the level on the dipstick. Depending on how much oil was drained previously and the capacity of the replacement filter, another 1/4 to 1/2 a quart may be necessary.
What else can I help you with?
Where is the oil pressure sensor for a 1997 GMC Suburban?
On the driver's side next to the distributor; hard to get to.
Does the distributor shaft on a 5.7 engine 1997 Chevy Suburban drives the oil pump?
Yes it does.
Is there a oil level sensor to shut down the engine due to low oil on a 1997 Chevy Suburban 350?
no, but its not a good idea to let oil get low
How do you Change the thermostat in a 1997 suburban?
Where is the thermostat on a 1997 chevy suburban and how do you change it?
What kind of oil do put in a 1997 Chevy Suburban 1500 ls?
cold pressed olive oil farcked mine up BIG TIME!
How much oil is required to change oil in a 1997 Harley?
how much oil is required to change oil and filter in a 1997 Harley Davidson Sportser
How much does it cost to replace a flywheel in a 1997 Suburban?
around 3-400 dollars
How much is a fuel filter for 1997 Chevy Suburban vortec?
About $14.00 for a good 1.
How much trans fluid capacity can a 1997 Chevy suburban?
A 1997 Chevrolet Suburban will hold approximately 4 quarts of transmission fluid. This fluid can be purchased at any auto parts store such as NAPA.
When did Suburban Base end?
Suburban Base ended in 1997.
How much can you get for your 1997 suburban?
Not knowing the condition, the junk yards are paying about $300 for complete vehicles.
Where is the oil cooler on a 1997 Chevy Suburban?
it`s in the radiator (notice two large lines on passenger side radiator tank)
