0
What else can I help you with?
How often do you need to change timing belt vw LT35?
The manual says 85.000 miles or 135.000 km on the 2.5TDI
Where is the engine number on a lt35?
The engine number on a LT35 can typically be found on the engine block itself, often stamped on a flat surface. Common locations include the front or side of the engine, near the cylinder head or oil filter. For precise identification, consult the vehicle's service manual or check with a dealership, as the exact location can vary by model year.
Where is the hazard relay on a vw lt35?
On a VW LT35, the hazard relay is typically located in the fuse box, which is usually found beneath the dashboard on the driver's side. You may need to remove the cover of the fuse box to access the relays. The relay itself is often labeled, but if you're unsure, consulting the vehicle's owner's manual can provide specific details about its location.
Where is the crankshaft sensor on VW lt35?
The crankshaft sensor on a VW LT35 is typically located near the engine's crankshaft, often mounted on the engine block or the transmission bell housing. It is positioned to detect the position and rotational speed of the crankshaft, which is crucial for engine timing. To locate it precisely, consult the vehicle's service manual, as the exact placement can vary depending on the engine type and model year.
What damage is caused by broken cambelt on volkswagen lt35?
bent valves and/or holes in pistons.
How do you remove lock barrel on sprinter?
how do i change locks on lt35 due to key snapped in barrell
Where do you put water in an LT35?
In an LT35 vehicle, you should put water in the radiator reservoir, which is typically located under the hood near the front of the engine. Be sure to check your vehicle's owner's manual for specific instructions on how to properly add water to the cooling system.
How do you replace cabin filter on VW lt35?
To replace the cabin filter on a VW LT35, first locate the cabin filter housing, usually found behind the glove compartment. Remove any screws or clips securing the glove compartment and gently lower it to access the filter. Remove the old filter, ensuring to note its orientation, and insert the new filter in the same direction. Finally, reassemble the glove compartment and secure it back in place.
How do you remove the oil filter of a Volkswagen LT35?
Open bonnet, look at engine, on right of engine is a black cylinder with a large black top (hexagon), unscrew this cap (will need oil filter removal tool), when cap comes off the filter will come with it, it's a bit stubborn but just pull out and replace with new and new rubber seals (2). tighten to 25nm
