answersLogoWhite

0

What else can I help you with?

Related Questions

Should you oil your paintball remote?

Only the o-rings.


Do new fuel injector o-rings need lubricated?

A little lubrication (motor oil) on the o-rings will make assembly much easier.


Does oil level switch for 97 sportsman have o rings?

Yes, the oil level switch for a 1997 Polaris Sportsman typically includes O-rings to ensure a proper seal and prevent leaks. These O-rings are crucial for maintaining the integrity of the oil system. If you're replacing the switch, it's a good idea to inspect the O-rings and replace them if necessary to avoid any potential issues. Always refer to the specific service manual for detailed information on parts and maintenance.


Can you use motor oil to oil a bb gun?

Never use Motor oil on a BB gun. It will eventually ruin the seals and O-Rings.


Where is the crankshaft sensor located on a 2005 Chevy Colorado?

it is located at the left rear of the engine block. it is held in with a bolt. make sure you replace the o-rings, and lube the o-rings with engine oil.


How do you position o rings on the water pump for 60 series Detroit?

When positioning O-rings on a 60 Series Detroit water pump, ensure that the O-rings are clean and free of debris before installation. Lubricate the O-rings with a compatible grease or oil to help them seat properly. Carefully place the O-rings into their designated grooves without stretching or twisting them. Finally, align the water pump correctly with the engine and securely fasten it to prevent any leaks.


Why does oil come out the exhaust on 1 cylinder diesel engine?

most likely bad o-rings or injector


How do you repair oil leak from the motor on a 1991 Chevy blazer?

I had a big oil leak in my 93 4.3 Blazer when I bought it and it turned out to be the remote oil filter block on the engine where the oil filter normally would go. There was a big O-Ring that was broked allowing oil to leak past it. I got an oil cooler repair kit from NAPA and it had the O-Rings to replace the broken one plus the oil line O-Rings. I had to remove a strut that went between the oil lines and remove the oil lines from the adapter so I could remove the adapter from the car to clean it and replace the O-Ring in the block.


Why is there oil on cylinder 3 and 4's spark plugs?

because the oil rings in those cylinders are worn.


How do you install an oil filter on 1999 e320 with the 3 different o-rings?

Standing in front of vehicle, it is on top and just to the right of the plastic engine cover. Round cylinder about the size of human fist. Use your hand and unscrew. One of the easiest oil filters to access in all of automobile land. The O rings are located on the stalk going from largest at the top to smallest on the bottom. Remove and replace with new.


Do you need any special sealant when replacing your ac condenser?

new o-rings coated with A/C PAG oil


Your corsa burns oil 1 liter 3 cylinder what can you do?

Get New piston rings!