attach a hose to the bleeder valve and put it into a clear jar filled with brake fluid, open the bleeder valve and have somebody push the brake pedal all the way down (you will see bubbles come out of the hose in the jar, that's the air in the brake lines), tighten the bleeder valve before they let the brake pedal come back up, and just repeat that till no more air/bubbles come out. be sure not to let the brake fluid level go down all the way otherwise you will have to start over.
from the furthest caliper from the master cylinder. Start with that one and move closer.
Yes, I recommend you bleed all brakes starting at the RR then LR, then RF, and end at the LF. It may not be absolutely necessary but then again it may be. To be safe just bleed them all.
To bleed the ABS brakes on a 1998 Dodge Dakota 4 x 4, two people are needed. One person needs to pump the brakes while the other opens the bleeder and then closes it making sure all air is out of the system.
you dont
what will make the brake light not work on a 1996 dodge dakota? fuses are good and bulbs are good
You should have your brakes fixed in a garage which is permitted, by the Dodge car company, to fix Dodge vechiles. To find the one near your home visit the Dodge homepage at www.dodge.com.
Either 7/16ths or 10mm
If you are following the proper procedures then the fluid will come out. Have someone pump and hold the brake pedal down, open the bleed screw on the caliper, pressure will force the fluid and air out.
you go to a mechanic, because this is probably the best advice you will get on the web.
A 5/16 brake wrench
You bleed the brakes just like you bleed any other cars brakes, there is no special way to bleed anti-lock brakes.
If you did not open any brake lines and only replaced the pads there is no need to bleed the system.