With utmost care :)
To remove the rear heater on a VW Sharan, first, disconnect the vehicle's battery to ensure safety. Then, remove any necessary panels or trim from the rear area to access the heater unit. Disconnect the coolant hoses and electrical connections from the heater, followed by unscrewing any mounting bolts that secure the unit in place. Finally, carefully pull the heater out and replace or service it as needed.
To remove the rear passenger light in a Citroën Picasso, start by opening the rear hatch and locating the light assembly. Remove the screws or bolts securing the light unit, then gently pull the assembly away from the body of the car. Disconnect the electrical connector by pressing the tab and pulling it out. Finally, replace or service the light as needed before reassembling the unit.
To change the rear light unit on a Skoda Fabia, first, open the boot and locate the access panel on the side of the light unit. Remove the panel by unscrewing or unclipping it, then disconnect the wiring harness from the rear light assembly. Unscrew the light unit from its housing and carefully pull it out. Replace it with the new unit, reconnect the wiring, and secure it back in place before replacing the access panel.
Remove the rear light cell to expose the sending unit. All will be clear then.....AP
To remove the rear light on a Ford Mondeo MK4, first, open the trunk and locate the access panel or cover behind the light assembly. Unscrew or unclip the panel to expose the rear light fixing screws or bolts. Remove these fasteners, then gently pull the light assembly away from the car body. Finally, disconnect the wiring harness to fully detach the light unit.
You need to find out first if your Sharan has dual units or single, if it has a rear unit then it will be under the interior trim by n/s/r wheel arch. Under the bonnet there is a sticker under the giving quantity of refrigerant required.
To replace the rear light cluster unit on a Peugeot 307, first, open the rear hatch and remove the access panel in the trunk interior to expose the light cluster. Disconnect the electrical connector and unscrew the securing bolts of the light unit. Carefully pull the light cluster out and replace it with the new unit, reconnect the electrical connector, and secure it with the screws. Finally, test the lights to ensure everything is functioning properly before replacing the access panel.
To change the rear indicator bulb on a Ford Fiesta, first, open the rear hatch and locate the light assembly. Remove the relevant access panel or screws to detach the light unit from the vehicle. Twist the bulb holder counterclockwise to remove it, replace the old bulb with a new one, and reassemble the light unit by reversing the steps. Finally, test the indicator to ensure it’s functioning properly.
Remove rear light unit cover in trunk. Turn bulb holder fastener 90 degrees counter clockwise and remove. Replace faulty bulb.
4 Screws, remove tailight unit, twist & replce infected bulb ......
The light bulb unit is found underneath the carpet behind each tail light area. Remove the plastic screws holding the trunk carpet to the interior sides behind the rear lights, follow the wiring to the center of the tail light, this is the light bulb unit-unscrew and remove.
if the high mounted brake light is in rear window. open trunk and access the light from below rear window shelf. if the light is in the spoiler, remove the screws holding it in. disconnect elec, connector from inside of trunk lid. the assembly has no replaceable bulbs, and has to be replaced as a unit..