0
You will need to go to your local parts store and make sure to get the correct oil pressure switch or if you have a local Cummins dealer you can ask them. I got mine there for a third of the lowest price. It is located on the drivers side of the motor and is be hind some electrical connections so it is hard to see. It is closer to the front of the motor. It takes either a 1 1/4 inch or 1 1/6 inch socket. Make sure and get it tight as to not have a leak but not over tighten and strip. Also MAKE SURE AND GET THE RIGHT SWITCH. If you get the wrong switch or the some of the single lines you may have to reprogram your ECM. If you are not experienced DONT TRY THIS. H&N Auto, Boise Idaho
What else can I help you with?
How do you change the Transmission Fluid Pressure sensor in a Dodge Ram 1500 truck?
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
A dodge ram 2500 diesel 2001 is the ecm hard to replace?
is the ecm on a dodge 2001, 2500 diesel hard to replace??
Is there an ac fuse on a 2007 dodge ram 3500 diesel?
There is a fuse, relay and switch on the low pressure side that will inhib compressor from turning on if there is not enough pressure.
Where is the fuel pressure switch on a Dodge Durango?
Dodge Durango is not equipped with a fuel pressure switch
What is DTC code P0521 on a 2003 dodge ram diesel?
* P0521 Engine Oil Pressure Sensor/Switch Circuit Range/Performance
Replace Block Heater in a Dodge Ram Diesel?
how do I replace block heater on 1995 dodge ram 2500
Where is the fuel safety switch on a 2003 dodge diesel?
Dodge does not use inertia/ reset switches.
Why does your lightswitch get hot on your dodge diesel?
The Plug that is hooked to the head light switch is melting, Get a new switch at a parts store, it will come with a new plug, it will be necessary to splice (solder) the plug. If you do not replace the plug and switch it will start a fire in the dash.
Where is the oil pressure sensor switch on a 2008 dodge caliber?
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
Can you replace a Dodge Ram 6 cylinder engine with a Dodge Ram diesel engine?
it depends on the size of the diesel engine going in so yes and no
Transmission Pressure in 1995 Dodge 2500 diesel?
Mainline pressure will be 55psi on a stock transmission
How do you replace the oil pressure switch on a 2004 Dodge Ram pickup 4.7?
To replace the oil pressure switch on a 2004 Dodge Ram 4.7, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the oil pressure switch on the engine block, typically near the oil filter; disconnect the electrical connector and use a socket to remove the switch. Install the new switch by threading it into place, reconnect the electrical connector, and finally, reconnect the battery terminal. Start the engine to check for leaks and ensure the oil pressure gauge functions properly.
