If the forks wont lift weight the seals in the piston may be worn..Turning up the pressure may not correct this problem..Most pressures in forklifts are factory set and should not exceed recommended values..There will be a relief valve near the pump or on the valve bank that will adjust the pressure. If the forks creep down especially with weight ...the seals are bad. If its just to lift something heavy and the forklift wont lift it, this item just might be over the forklifts capacity. If there is Water in the oil this can cause probs too.
replace the hydraulic tappets in the rocker arms, valves are non adjustable.
How do you adjust the valves on a 1995 isuzu Rodeo 3.2
how do you adjust head ligths up or down on a 2001 Isuzu rodeo
adjusting Isuzu rodeo brakes
how much fuel pressure should a 1999 Isuzu amigo have
16mm street
diagram of rpm in trooper
there are no adjustment less you have air shock
need a picture of a 2002 Isuzu engine. Need to know where the fuel pressure regulator is located.
On a 2004 Isuzu NPR tow truck, the hydraulic fluid reservoir is typically located near the rear of the vehicle, often near the hydraulic pump. To add hydraulic fluid, locate the reservoir cap, remove it, and pour in the appropriate type of hydraulic fluid until it reaches the recommended level on the dipstick or gauge, if available. Always consult the owner’s manual for specific instructions and fluid specifications.
The timing is not adjusable It is distributorless ignition
need a picture of a 2002 Isuzu engine. Need to know where the fuel pressure regulator is located.