0
How to replace CV joints on 93 Honda prelude And will the trans-axle fluid have to be drained to do so?
If the CV boot is torn open, buy a remanufactured halfshaft axle and replace the whole halfshaft (includes the joint). To replace the boot and/or halfshaft axle on some early 90's model Hondas: First, remove the wheel cover and loosen the 36mm nut holding the joint to the bearing. Then raise the vehicle and remove the lower ball joint from the lower control arm and the knuckle. If your working on the passenger side, drain the transmission. Slide the half shaft out of the knuckle then use a prybar and pry the inboard end of the shaft out of the transmission or intermediate shaft, which ever should apply. Be careful not to damage the seal in the transmission. Installing the shaft is the reverse of removal. The inboard side of the shaft should snap right back into the intermediate shaft and transmission by means of a snap ring on the end of the shaft.
What else can I help you with?
How do you take apart the axles on a 90 civic DX?
the only parts that you can replace on the axle shaft are the cv joints that go into transaxle Cheaper to buy new axles 75 to 100 each side
Would a 1989 Honda prelude 2.0si have rear upper and lower ball joints?
Yes.
How do you replace your front ball joints on Lincoln ls?
How do you replace your front ball joints on a Lincoln
How much to replace cv joints?
The average cost to replace CV joints is approximately $300. It is more inexpensive and less time consuming to replace both CV joints.
How do you replace the CV joints on a 1993 Nissan Sentra XE?
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
How do you replace the ball joints on a 1998 Monte Carlo Z34?
How do you replace the ball joints on a 1998 Monte Carlo Z34??
Knocking sound when turning?
Bad CV joints. Replace the CV joints.
How do you replace ball joints on 1995 Nissan truck?
how to replace lower ball joints on 1995 4 wheel drive Nissan truck
How do you replace ball joints 1997 mercury villager?
The ball joints are bolt on parts that don't require any special tools to replace.
Fixed-style cv joints are typically located nearest to transaxle?
Yes, the outer joint has to be flexible so that you can turn and move up and down.
How do you replace ball joints on 2007 ford sport track 4X4?
please answer my question on how to replace ball joints 2007 ford sport track?
How do you replace bad cv joints on a 2001 ford focus?
Just replace the entire half-shaft driveaxle. It is really pointless to try to rebuild a CV joint when it's only $75-$100 for the whole half-shaft driveaxle. NOTE: The passenger side is very easy. The driver's side is notorious for being tough to get out of the transaxle. Good luck.
