answersLogoWhite

0

Every 5,000 miles, a "Maintenance Required" light will blink for the first couple seconds after you start your car. It will continue to do so until it is reset. If it is not reset, than it will eventually turn on your "Check Engine" light. The purpose of the maintenance required light is to remind TC owners to change their oil. The factory recommended interval is 5,000 miles, but you can reduce the interval the light will come on to a mileage interval of your choice.

1. Before starting, make sure that the odometer is not on one of the trip mileage odometers but is displaying the standard odometer.

2. With the car off, press and hold down the odometer reset button. While still holding it, start the car.

3. The light should continue to blink for a couple seconds and than disappear. That will reset the light for another 5,000 miles.

4. The following are steps to change the interval in which the maintenance required light comes on. Right after you turn on the ignition while holding the reset button, you'll notice that the odometer display will show 5 bars. Each bar corresponds to a 1,000 miles. As each bar disappears, the interval will increase (0 bars = 5k, 1 bar = 4k). Release the reset button at the interval you desire.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you reset check engine light on 2007 scion Tc?

To reset the check engine light on a 2007 Scion tC, you can disconnect the car's battery by removing the negative terminal for about 15 minutes. This will clear the engine's computer memory and reset the light. Alternatively, you can use an OBD-II scanner to read and clear any trouble codes, which will also turn off the check engine light. Always ensure that any underlying issues are addressed before resetting the light.


How do you reset check engine light on a scion?

To reset the check engine light on a Scion, you can use an OBD-II scanner to clear the trouble codes stored in the vehicle's computer. Alternatively, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. This method may reset the light, but if the underlying issue isn't resolved, the light will likely come back on. Always ensure that any mechanical problems are addressed before resetting the light.


How do you Reset Scion airbag light?

how do i reset srs light on scion tc


How do you reset the change engine oil light on a 2006 Scion XB?

change the oil


How do you reset the check engine light on a 2008 Chrysler Sebring?

The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.


How do you reset airbag light?

how do i reset srs light on scion tc


How do you reset the check engine light on a 1999 volkswagen jetta?

The check engine light has to be reset with a OBD scan tool


How do you reset the check engine light on 2007 dodge with cummins engine?

You reset the check engine light with a scan tool after repairing the failure.


How do you reset the check engine light in a land rover discovery?

hoe do you reset the check engine light in a 1995 land rover


How do you reset a check engine light 1999 Acura 3.2 TL?

how do i reset the check engine light on a 1999 acura 3.2tl


How do you reset check engine light on 1989 lesabre?

The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.


How do you reset the service light in a 2008 scion xd?

To reset the service light in a 2008 Scion xD, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine to ensure the service light has been reset successfully. If the light remains on, repeat the process.