Jump start it from another vehicle or charge the battery. If the battery is bad, replace it. If you jump start it and the battery is dead you will have to wait about 15 minutes with the jump car running and connected to the dead battery, in order to build the battery up enough for it to actually take a jump.
where is the fuse box in a Toyota solara
Click the link.
3.0
The 80 amp fuse for a 2000 Toyota Solara is located in the engine compartment fuse box. This fuse box is situated near the battery, typically on the driver's side. You can find the specific fuse by referring to the fuse diagram on the cover of the fuse box for identification.
To change the dash lights on a 2000 Toyota Solara, first disconnect the negative battery terminal to ensure safety. Remove the instrument cluster by unscrewing the screws that secure it, then gently pull it out. Locate the burnt-out bulbs, twist them counterclockwise to remove, and replace them with new bulbs. Reassemble the cluster, secure it back in place, and reconnect the battery.
it probably needs a new battery
dexron III
One year and possibly some color options. The first year for the Generation II Solara (different body style) was 2004. Cheers
To replace the EGR valve sensor on a 2000 Toyota Solara V6, first disconnect the negative battery terminal to ensure safety. Remove the EGR valve by unscrewing the bolts that secure it, then disconnect the electrical connector and any vacuum lines attached. Install the new sensor by connecting it to the EGR valve, securing it with the bolts, and reattaching the electrical connector and vacuum lines. Finally, reconnect the battery terminal and start the engine to check for proper operation.
Kelly Blue Book kbb.com
5 qt
To replace the knock sensors on a 2000 Toyota Solara, first disconnect the negative battery terminal to ensure safety. Then, remove the intake manifold to access the knock sensors, which are typically located on the engine block. Disconnect the electrical connectors from the old sensors, unscrew them using a socket wrench, and install the new sensors in the reverse order. Finally, reassemble the intake manifold and reconnect the battery.