Asking such a broad question indicates you should not be trying to do this task. The bumpers are integral to the car's safety system as well as containing crash sensors and are not something you want to mess with. In addition the nuts and bolts holding the bumper on are to be tightened to specifed tightness, requiring a special torque wrench. Any decent garage should fix this problem for you for $50 max; if not, find another garage!
You have to break it and ha ha ha !
yes
The 1992 Mercedes-Benz 300 rear bumper is held in place with eight retaining bolts. You can remove the rear bumper by removing the retaining bolts.
If the bumper is in excellent condition then yes they can use it to repair your car.
To change the rear parking sensors on a 2002 Mercedes S-Class, start by removing the rear bumper, which typically involves unscrewing bolts and clips. Once the bumper is off, locate the parking sensors, which are usually mounted in the bumper itself. Disconnect the wiring harness from the old sensors, remove them, and then install the new sensors by reversing the process. Reattach the bumper, ensuring all clips and bolts are securely fastened.
InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.
To remove the rear bumper from a Mercedes W126, first, ensure the vehicle is securely positioned on flat ground. Begin by removing the screws and bolts located under the bumper, typically found near the mounting points on each side. You may also need to detach any clips or wiring connected to the bumper. Once all fasteners are removed, gently pull the bumper away from the vehicle, being careful not to damage any surrounding components.
I believe it is located inside the rear bumper. The antenna on the roof of the car is for the tele aid/telephone.
how to remove 2013 passat rear bumper
The rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off. Reverse the process to install your new rear bumper.
Yes. All 107 body cars car basically interchangeable. Personally, I'd get the much older or Euro bumper, wich is much smaller and looks like a zillion times better.
Removing the Rear Bumper of a Passat...