answersLogoWhite

0

Should be located at the upper end of the brake pedal under dash area Check to see that one side has power at all times and the other side only gets power when switch is closed

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is the cause for brake lights not working in a 2002 Hyundai santa fe?

Brake lights not working in a 2002 Hyundai Santa Fe could be caused by a blown fuse, a faulty brake light switch, or burned-out bulbs. First, check the fuse box for any blown fuses related to the brake lights. If the fuses are intact, inspect the brake light switch, located near the brake pedal, as it may be malfunctioning. Lastly, ensure the bulbs themselves are functional and properly seated in their sockets.


How do you check brake light switch on 2004 Hyundai tiburon?

To check the brake light switch on a 2004 Hyundai Tiburon, first, locate the switch, which is typically mounted on the brake pedal assembly. Disconnect the electrical connector from the switch and use a multimeter to test for continuity; the switch should show continuity when the brake pedal is pressed. If there's no continuity, the switch may be faulty and should be replaced. Additionally, inspect the switch for any signs of damage or misalignment.


Why do you brake lights not show when you brake?

check wiring, check bulbs, check fuse, check brake light switch,


Where is brake fluid located for Hyundai Santa Fe?

In a Hyundai Santa Fe, the brake fluid reservoir is typically located near the back of the engine bay, on the driver's side. It is a translucent container with a cap that is usually labeled with a brake symbol. To check the brake fluid level, you can look through the reservoir's side; the fluid should be between the "MIN" and "MAX" marks. Always ensure the vehicle is turned off and cool before inspecting the fluid.


How many quarts of brake fluid does it take for a 2006 Hyundai Santa Fe?

A 2006 Hyundai Santa Fe typically requires about 1 to 2 quarts of brake fluid for a complete brake system flush or refill. However, the exact amount can vary depending on the condition of the brake system and whether you're just topping off or doing a full replacement. Always refer to the owner's manual for specific recommendations and check the brake fluid reservoir to determine if you need more.


85 s10 blazer brake lights wont work?

Check fuse, check bulbs, check brake light switch, check wiring and then check signal switch, in that order.


Why do the brake lights dim on a Hyundai Accent when the headlamps are turned on?

Check the ground wire to the brake lights.


2002 ford explorer brake lights stay on all the time?

check brake light fuse and brake light switch on pedal


Why don't brake lights work on 92 s-10 but other lights do?

Check the brake light fuse, the bulbs, the brake light switch and last, check the signal switch.


Why are my 97 s-10 brake lights not working?

First check the brake light fuse, then the brake light bulbs and lastly check the brake light switch. If all that checks good you may have a faulty signal switch (AKA the multifunction switch).


What would cause an interior brake light to stay on in 1997 ford escort?

Check you brake fluid and the brake switch on the proportioning value. If the fluid level is ok then disconnect the switch to see if the light goes out. Also check the parking brake switch.


Where is the fuel sensor located on a Hyundai Santa Fe 2.2 CRTD?

Check