3 things could cause this code, the nvld vent valve has failed internally, the wiring to this component has an issue, or the engine control computer itself has failed. the nvld vent valve is in the rear of car, near the charcoal canister and vent filter. check resistance across pins on nvld corresponding to orange wire and white/dk grn wires. ensure black wire has good chassis ground. if no probelms found, disconnect pcm connector 3 (white), and check continuity of orange wire and white/dk wires (pins 8 and 35 if memory serves me). if problem is still not found, then the engine control module most likely needs to be replaced. hope this helps
There could be a short to ground circuit . The fuel pump control circuit may also be sticking open which would also cause this fault.
After repairing the cause, the code is reset with a scan tool.
Trouble code P1504 means: Idle air control (IAC) circuit malfunction
The cause for an error code p1361 on a Buick Park Avenue is ignition control circuit low voltage. The power or wiring leading into the circuit is damaged or incorrect.
there is a thermoswitch in the circuit, when the temprature drops, the switch opens the circuit and shuts off the fan.
No, overcharging cellphone will not cause an electrical short circuit.
An ammeter can cause a short circuit if it is connected in parallel instead of in series with the circuit being measured. This can create a low resistance path for the current to flow, bypassing the intended circuit and causing a short circuit.
A spark from a short circuit can cause a fire .
This causes flow because voltage is what powers a circuit
P0447 Evaporative Emission Control System Vent Control Circuit Open Possible open circuit, check the connector at the evap canister for water and corrosion as this part is exposed to the elements and wet weather will cause moisture to enter the connector and replace the part as soon as possible your gas mileage will improve :)
Most likely a short circuit will cause no voltage. Due to the high current on a short circuit fault the over current protection of the circuit will trip. This will cut the voltage supply off completely.
Trouble code P0480 means: Low Speed (No. 1) Fan Relay Control Circuit