If by "front" fan you mean the radiator cooling fan, then the answer is NO, the fuse would not cause it to blow, other than it allows the fan to receive electric current from the battery, through the automatic fan control switch.
The radiator electric cooling fan is controlled by a thermostatic switch [usually located in the coolant system] which is supposed to turn the fan on when the coolant temperature gets above a certain point.
If that switch "sticks" in the closed position, then the fan will run all the time.
Also, it is important to note that the fan will normally operate for a short time after the engine is shut off, until the radiator coolant cools down below the temperature programmed into the control switch.
On a 2010 Ford Fusion, the claimant control can stop the air-conditioning blower from blowing air.
If the AC stopped blowing air on your 2003 Toyota Echo, the blower fuse could be to blame. If the fuse is fine, it might be the blower resistor that needs to be replaced.
first thing to check is the fuse
mor vehicle info would help, but blower motor can be shot without blowing fuse
If a Jeep Grand Cherokee's air conditioner is not blowing any air it could mean that the blower motor has went out. Also the AC controls could be bad.
sometimes this is caused by the blower resistor heating up and shutting the circuit down, or it could be in the blower itself heating up and shutting down.
You don't say the reason for the blower motor replacement. Did it not blow ? If that be the case, and you do have a new blower, check for 12 volts to blower. Could also Abe a malfunctioning blower module. Now if its blowing COLD air, well , replacing the blower moter wont make it blow warm. There could be numerous causes of that problem
Defective blower motor switch, or defective blower motor resistor pack.
Blower motor working? Could be bad vacuum motor or connection could be plugged evaporator
If your Safari GMC air is blowing in low only, you should check for loose vacuum lines. It could also be that the blower is about to go out and will need to be replaced soon.
Could be either or, but also a switch, not to exclude wiring or connections.
If your Ford E-250 blower isn't blowing on high, it could be due to a faulty blower motor resistor, which regulates the fan speed. A blown fuse or a bad connection in the wiring could also be responsible. Additionally, the blower motor itself might be failing. It's best to have these components checked to determine the exact issue.