Depends on the amount that was added. Brake fluid is not a a sufficent lubricant, so if enough was installed it can do damage.I personally would, Drain the oil, change the filter, install a new filter, and add the correct amount of oil. I heard you can reconduction an old engin with brake fluid , free up rings and soften rubber seals to seal better. You use 1/2 a bottel and run for 1 or 2 hours
brake fluid doesn't have the viscosity that motor oil does and it will not lubricate engine parts properly. It would definetely cause some major damage at some point.
Yes
In vehicles: Differential Usually 90 Weight gear oil Transfer case (if 4wd) Transmission Fluid Power steering fluid Windshield washer fluid Brake Fluid Coolant Fluid (antifreeze) Motor Oil Brake Fluid
motor oil, transmission fluid, rearend grease, power steering fluid, and brake fluid.
don't try it
Motor oil, trans fluid, gear oil, power steering, washer fluid, coolant, brake fluid, gas..... Please be more specific
All, master cylinder, brake calipers, and wheel cylinders, must be flushed out. Motor oil causes the seals to swell and lock up brakes.
Probably nothing other than brakes that do not work well. You need to have the brake system completely flushed and fresh brake fluid installed or it will ruin lots of expensive parts.
coolant, motor oil, power steering fluid, transmission fluid, brake fluid?
The term "liter" when spoken about on a motor vehicle or car is usually referring to the quantity measurement of fluid, whether it is: motor oil, transmission fluid, brake fluid, coolant, etc..
Not for motor vehicles, use the correct oil. If brake fluid can burn paint off bodywork I don't think it would be good using it as a lube.
Only brake fluid can be used for brake fluid. Brake fluid is a glycol-based liquid - it's closer to antifreeze than to oil, but don't use antifreeze in it either. Only brake fluid.