0
There are two of them on a 1996 Beretta. One is mounted in the rear exhaust manifold. You should be able to see it by looking under the hood, straight down the back of the engine. The other is located just before the catalytic converter. Poke your head under the car and look for the big "bubble" in the exhaust pipe closer to the engine.
What else can I help you with?
What can make a vehicle diagnostic test read fuel too rich on a 1996 Chevy Beretta?
Bad oxygen sensor, fuel injector bleed, timing off.
Where is a thermostat in a Chevy Beretta v6?
I'm looking where the therma stat is location in a 1996 Chevy bratta at
How do you adjust timing on a 3.1 Chevy Beretta 1996?
Computer controlled and not adjustable
1996 Chevy beretta leaks at the bottom is it the slave cylinder?
oil leaks
1996 beretta oxygen sensor?
There is normally one before the catalytic converter and one after.
Where is voltage regulator located on 1996 Chevy beretta?
The voltage regulator is built into the alternator.
Where the nock sensor in 300zx motor?
diagram of a nock sensor in a 300zx 1996
What does a diagram show of 1996 Chevy Corsica Cooling system?
WHAT DOES THE DIAGRAM SHOW?
What is the torque for the head bolts for a 1996 Chevy beretta 3.1 4 cylinder?
The 3.1 was a V6
Where is the crankshaft sensor 1996 Chevy 1500?
how to tell if my crankshaft sensor is not working
1996 Chevy blazer where is bank 1 Sensor 2?
The bank 1 sensor 2 on a 1996 Chevy Blazer is mounted in the exhaust. Sensor two is just behind the catalytic converter.
Engine diagram for 1996 Chevy Tahoe?
how much oil does a 1996 Tahoe hold
