0
What else can I help you with?
When replacing battery mileage changed how do you correct?
Etron provides you best e-rickshaw battery and other component dealer.
Car clock keeps resetting when starting car?
First clean battery connections, if this does not correct problem the battery needs replacing.
Why is my fire alarm still beeping after replacing the battery?
If your fire alarm is still beeping after replacing the battery, it could be due to a few reasons such as a faulty battery, improper installation, or a malfunction in the alarm itself. It's important to check the battery connection, ensure it is the correct type of battery, and if the issue persists, consider replacing the alarm unit.
What size battery for a ford grand marquis1987?
The battery size for a 1987 Grand Marquis is a 4.6L. It is important to always check to make sure you have the correct size battery when you are replacing you battery..
Why is my smoke detector still chirping even after I replaced the battery with a new one?
If your smoke detector is still chirping after replacing the battery, it could be due to a few reasons such as a faulty battery, improper installation, or a malfunctioning detector. It is recommended to check the battery connection, ensure it is the correct type of battery, and if the issue persists, consider replacing the smoke detector itself.
How do you replace the battery in a 2001 Chevy Tahoe?
Replacing a battery in a 2001 Chevrolet Tahoe is very easy to do. You will just need to take off the battery cables off the battery and put them to the side. Remove the old battery and replace with the new one. Put the cables back on the correct posts.
Can you put a flywheel in a 3.9 dodge Dakota backwards if it has an auto trans?
the flywheel in an auto is called a flex plate yes it can be installed backwards, but it will cause problems the ring gear for the starter will not be at the correct distance for starter to engage. the torque converter for the transmission bolts onto the flex plate. the flexplate has balancing weights on it. these weights will be in the way of properly mounting the torque converter
I put a new battery in my 1990 sundance now it wont turn over?
Did you install a fully charged battery of the correct group size and connect the cables securely? Did you incorrectly jumpstart the car with the cables reversed and break things before replacing the battery? Did it turn over before you replaced the battery?
Why is my fire alarm chirping after I installed a new battery?
The fire alarm may chirp after installing a new battery due to issues like improper installation, low battery voltage, or a malfunctioning alarm. Check the battery connection, ensure it is the correct type, and if the issue persists, consider replacing the alarm.
Is there any type of trick to line up the throw out bearing?
The throw out bearing usually snaps in place on the clutch folk. There is a alignment tool you can use to align the clutch disc with the pressure plate. Also note the correct torque when mounting pressure plate to flywheel.
What size mounting bolt on a 1987 Ford Ranger?
To receive a correct answer more information will be needed: (mounting bolt for ???).
Why when I replaced the starter in my '91 Toyota Camry it sometimes would start sometimes it wouldn't and when it wouldn't you had to wait a few hours before it would start again?
battery needs replacing, make sure you replace it with a battery of correct cranking amps
