0
What else can I help you with?
What style of pants are bell bottoms?
Bell bottoms are kind of like flared pants; where the bottom of the pants get wide and the top are slim.
What kind of flashing goes at the bottom of a chimney?
fire Lead.
What kind of cheese goes on a bean burrito at Taco Bell?
The bean burrito at Taco Bell contains Shredded Cheddar Cheese.
Im thinking that a 94 sunbird's starter would have to be changed by removing the front axel as well if so passenger or driverside?
The starter can be changed from the bottom of the car you will need a long extensions to reach the bottom bolt which you can see in between the engine and the transmission. The second bolt goes through the bell housing of the transmission and is removed from the drivers side its kind of hard to see but its there just feel for it. You don't have to remove the axel at all that's a waste of time. Its kind of in a bad area and hard to do.
What kind of housing do they have today in America?
what kind of housing do they have in America today?
Where to you put the manual transmission fluid on a 1988 BMW 325I and what kind do I use I heard brake fluid and clutch brake fluid. I am confused.?
I had the same question. The transmission fluid actually goes in the power steering reservoir. Kind of strange, but true. For the type of fluid you want to use, check your bell housing. There should be a sticker on it that says what to use.
How do you change clutch fluid on Honda civic?
nbjbkbhkbhj What kind of answer is that? Anyway, the real answer is that if you are talking about the fluid in the transmission, there's a train plug on the bell housing and a fill hole above that, fill until fluid reaches the bottom of the hole and you can stick your finger in a feel it, or get autozone to print off the capacity for you. If you are talking about old dot3 fluid for the clutch master and slave cylindars, the easiest way is to suck all the fluid out of the reservoir, and then bleed new through it until it runs clear via the slave cylindar in the front of the engine on top of the bell housing. -Willpower101
Just changed the clutch on your 1994 jeep wrangler and now it wont fire up. Is there some kind of electrical switch that needs reset?
Crank sensor, upper drivers side of bell housing
Where is the PCV valve on a 93 ford bronco 5.8?
On the 91 5.8L, and Im sure the 93 is the same. Its located at the rear of the engine, on the passenger side. its a short small hose attached to the top of it and about a 3/8" hose on the bottom. This hose goes into the intake, behind the air intake housing, its kind of hard to get it back in, but you can do it
Subsidized housing is an example of what?
An in-kind benefit
What kind of clothes did bon Scott wear?
really tight fitting t shirt's, tight bell bottom jeans 1970's style, nike tennis shoes or boots.
What kind of clothes were warn in the 70's?
Bell-bottom or boot-cut jeans, tie-dyed clothing, cowboy boots, floral- and abstract-patterned bandanas, necklace and accessory galore!
