0
What else can I help you with?
Diagram for the location of a knock sensor on a 2002 Chevy Tahoe.?
2003 chevy tahoe knock sensor
Location of knock sensor on 2008 Chevy silverado?
under the dome
Where its locate knock 1 sensor in vortec v8 4.8?
The knock 1 sensor on a Vortec 4.8 is located on the top of the engine. You will have to remove the intake to gain access to replace it.
Where is the knock sensor located on a 2003 Chevy Tahoe 5.3 l vortec?
That engine has 2 of them and there underneith the intake manifold. You will have to remove the intake to get to them.
Where is the knock sensor located on a 95 Chevy blazer?
The knock sensors yes there are two are located on either side of the motor (4.3LTR Vortec) below the heads in the center area of the engine block. There are a place for another sensor just above where the knock sensor goes but these are for other sensors. The knock sensors yes there are two are located on either side of the motor (4.3LTR Vortec) below the heads in the center area of the engine block. There are a place for another sensor just above where the knock sensor goes but these are for other sensors.
Where is the location of knock sensor 1996 Chevy S-10?
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
Where is the location of crankshaft position sensor on a 2006 Chevy Silverado HD Duramax?
The Duramax don't have a knock sensor.
Where is the knock sensor located on a 1996 Chevy 2500 4wd 5.7 vortec?
It is screewed into the passenger side of the engine just in front of the starter. It is hard to see.
Where do you find the knock sensor in a 1999 Chevy lumina?
Where do you find a knock sensor on 1999 Chevy lumina
Where is the anti-knock sensor on a 2003 Chevy Avalanche?
you mean knock sensor
How do you change the knock sensor in a 2003 Chevy Silverado 5.3?
how do you change the knock sensor in a 2003 Chevy silverado 5.3
What would make a knock sensor go bad in a Chevy truck?
A common problem with GM vortec engines is that they dont seal the knock sensors very well and moisture gets into them. the fix is to replace the sensor, and build a dam of rtv silicone around it, keeping water out.
