answersLogoWhite

0

I have the same problem with my car horn steering wheel button. There is the problem with the horn relay switch. You need to open up the steering wheel and carefully determine the wires that are connected to the switch. In my vehicle's case, the relay switch is tucked in along with the airbag, which made it impossible for me to pull out the whole relay. I was hesitant to pull the relay out as it may render the airbag useless (as it may trigger accidental inflation), so I had to go with identifying the wires connected to the horn relay switch only. Once the wires were identified, I had to bypass the connection to the steering wheel relay switch and reroute the wires into a vacant spot on the dashboard. With a switch improvised, I can trigger the horn from where I mounted the switch, which is just below the steering wheel.

Have a car electrician look at the problem and he may give some ideas on how to solve your horn problem. Good luck.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace the lights in the radio and AC buttons on the steering wheel on a 1993 Delta 88?

You have to replace the whole button.


How do you replace light on button on steering wheel on duramax diesel?

Most steering wheel buttons bulbs are not serviceable, you must replace the button(switch) or the shole horn pad, most dash and switch bulbs are not serviceable


What is the plural of button?

Buttons is the plural of button


Which buttons are a b and c on tamagotchi v3?

Well the buttons on the Tamagotchi system are in order. (far left) A (middle) B (far right) C


How do you declare an array of buttons in Java?

To declare an array of buttons in Java, you would use the following syntax: Button[] buttonArray = new Button[n]; where n is the number of buttons you want in the array. This creates an array of n buttons, where each element can hold a reference to a Button object.


How do you set the Cruise Control on a 1997 Nissan Altima GXE?

Its not the button on the top!!! It's the button on the bottom the one on the top turns it off after it's on. to the left of the steering wheel, on the left side of the dash , there are two buttons; push the top one. the cruise control is then enabled, then press the set/ accel. button on the steering wheel.


What is the button on the left side of the steering wheel of a Saturn ion?

The button on the inside left of the steering wheel is the power button to turn on the Cruise Control. The buttons on the inside right of the steering wheel control the acceleration and deceleration of the cruse control. To initialize cruise control you must get the car up to speed, turn the cruise control power button on. Then once at the desired speed depress the minus (-) button on the lower inside left of the steering wheel one time to engage. From there you can choose to go faster or slower by pressing and holding down on either the + or - symbol's.


Where is the trunk release button inside a Lexus SUV?

On the left and slightly below the steering wheel, next to the buttons to adjust the side mirrors. It says "power door."


How do you set the clock in a 2012 Toyota Highlander Limited?

I was totally puzzled by the same problem - - followed the Owner's Manual instructions explicitly to no avail. Problem is - - there are two (2!) DISP buttons - - a prominent one on the dashboard - - a less prominent one on the steering wheel. It's the steering wheel one that you want to press and hold to access the clock reset functions. (Then make a note in your Owner's Manual that it's the DISP button on the steering wheel.)


What is a button machine?

a button machine is a machine that makes buttons.


Should your panic button be wired to the no or nc terminal. It doesn't say in the instructions.?

If the circuit of the panic button is monitored for a break in its circuit, the contacts will be in a N.C. configuration. There will need to be a relay in the circuit that is kept energized by the buttons closed contacts. When the relay drops out, its N.C. circuit contacts will activate the panic buttons load. If the panic button has no monitoring features then the contacts across the button will be wired in the N.O. configuration. When the button is pushed the circuit closes.


Why does only the volume button light up on a 2001 Aurora the other buttons on the steering wheel do not on this car?

it's either multiple bulbs or a broken circut some where in the system.