if I am not mistaken, the lights in the dash are from fiber-optic lines that go to the switches from the cluster lights. also originate from the rheostat in cluster.
Where and how do you change the fuse for the dash bord lighting sytem in the 1993 190e 2.3l
my 1993 190E 2.3 is doing the same thing. just replace the switches...they tend to not last
A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.
By using a tool box open the location and remove it to replace it with a new one
the wire is bare how do you replace the wire with out removing the dashboard on a 1993 Chevrolet corsica?
Remove ALL dashboard screwscarefuly remove the dashboard,andyou will see were the bulbs are located,replace any/and/or/allthe bulbs needed,and reverse theprocedure to reinstall ! That's it !
you take out the dashboard, take off the trip to the actual dashboard 2 screws, one left of the steering wheel, one right, then pull the trim off to the left then you will see 3 screws holding the dashboard in place one left one middle, one right once you have all those off pull dashboard out unplug all connectors and remove the dash you will find most lights there some will be hidden under a casing which you will need to completely remove to get to them.
For a 190E 1984 Model, it is about 60Litres, this is 13 Gallons(UK) or 16 Gallons(US). For a 190E 1993 Model it should be the same +/- 5Litres.
There is no filter:)
this is sooo easy.use the trip odmomiter knob but instead pushing it to reset to "0" turn it either to adjust lights
You have to replace the whole button.
The blower motor for a 1993 Mercedes 190E is located under the dashboard on the passenger side of the vehicle. To access it, you typically need to remove the glove compartment and possibly some paneling. The blower motor is mounted to the HVAC housing, making it essential to be cautious during removal and installation to avoid damaging any surrounding components.