0
It might have four hoses?
Pcv and Brake booster go to separate large ports, the pcv usually to the carb base and the booster to the manifold fitting.
Vacuum advance goes to one of two small ports on the carb. Test to find the one that has no vac at idle but as soon as you touch the throttle you get vacuum.
Cruise goes to either the small port on the intake or the carb base. It could be split off the vacuum advance.
What else can I help you with?
Carter AFB carburetor vacuum diagrams?
i need vacuum diagram for a carter abf competition 8867
What 4 barrell carb should your 1988 4x4 Dodge 360 have on it stock?
Its a Carter Thermoquad. Essentially, its a 3 pc. 4 bbl Carter with the top plate/bottom plate made from metal like a reg. carb but the center section is made from Thermo plastic..thus the Thermoquad name.
What cfm is a Carter 2794s carburetor?
750
What cfm is a carter 8867 carburetor?
750 CFM
What ia a Carter 46005?
Never heard of this carburetor.
What is the advantage to swap a stock Carter Carburetor to a Weber 34 on a Jeep CJ7 6 cylinder?
no advantahe at all stick with the original
What cfm is a carter 8867 carb?
The Carter 8867 carburetor is typically rated at 650 cubic feet per minute (CFM). It is commonly used in performance applications for small-block engines, providing a good balance of airflow and fuel delivery for enhanced power and efficiency. This carburetor is known for its reliability and is often favored in street and mild race setups.
Can Carter bbd 2bbl carburetor used on Chrysler 318 be used on Plymouth 273 engine?
Yes, same block, same basic engine. I have a 273 with 318 heads on it, and a 2 barrel Holley, but the Carter BBD was stock.
Do you got to change the manifold if you change the carburetor?
It depends, if you get the exact same carburetor, then no, but if say you upgrade from a single barrel carter to a 4 barrel edelbrock then yes, but if you already have a 4-barrel carb and manifold then you may need a adapter which is inexpensive, but you could also get lucky and it may bolt right up.
How do you know if your carburetor needs replaced?
Carburetors are fairly simple parts to rebuild, therefore going out and spending over 150.00 is not something I would recommend. The only way I would actually replace one is if one of the sections is warped and leaking fuel, or the carburetor has caught fire. Rebuild kits usually cost between 20.00 and 75.00. If you are having an issue with fuel delivery, inside the carburetor. You may look at replacing the accelerator plump diaphragm or the blowout valve on the carburetor, also the fuel filter. If you have a Carter, or a Chrysler Carburetor, the accelerator pump is internal, just rebuild it. Thank You Good Question,
Where does the vacuum advance hook up on carter four barrel carb?
On a Carter four-barrel carburetor, the vacuum advance typically hooks up to a ported vacuum source, which is usually located on the carburetor's throttle body. This port provides a signal that varies with engine speed and load, allowing for optimal ignition timing under different operating conditions. Ensure to connect the vacuum line to the correct port to achieve the desired performance and efficiency.
What size carburetor was on the 1963 Chevrolet Impala SS 283?
I would say a 500 CFM but no bigger than a 600 CFM. I don't know if you are looking for an answer on flow (CFM) or just a generic answer like "two barrel" or "four barrel". As I recall, in 1963 the 283 was only offered with a two barrel carburetor. I believe the rated horsepower was 195. The carburetor was either a Rochester or a Carter. Flow was likely not more than 400CFM.
