Typically, the oil pressure switch is located on the oil filter adpater near the bottom of the engine on the front side. If your car doesn't have one, there will be an aluminum hex-wrench plug in its place.
on the pipe that leads into the inlet manifold from turbo, the one with a metalic wire when you take it out
The exhaust back pressure sensor or EBP on the 04 is located by the upper radiator hose by the block. It has a 3 pin connector and accepts a 24mm socket.
it has a turbo diesel model.
where is the turbo super boost sensor located onth 2001 S60 24 T
yes they are perfectly legal my jetta has a turbo
In a 2001 Volvo S60, the turbo boost sensor, also known as the manifold absolute pressure (MAP) sensor, is typically located on the intake manifold. It is mounted near the throttle body, connected to the manifold with a rubber hose. To access it, you may need to remove some engine cover components for better visibility. Always consult the vehicle's service manual for precise location and removal instructions.
No such part on a 1993 Cummins
No, they are not interchangeable.
well that all depends witch hose answer this does it go from the turbo to the waistgait or is it a oil and or colant hose but obviously its do to over pressure manly causes pops try new clamps
On a 2001 Dodge truck, the turbo boost sensor, also known as the manifold absolute pressure (MAP) sensor, is typically located on or near the intake manifold. It can be found on the driver's side of the engine, mounted to the intake manifold or in the vacuum line leading to it. For precise location, it’s often best to refer to the vehicle’s service manual or consult a repair guide.
no the 85 it is on the fuel pressure reg it should be the same
The exact mounting location of the turbine speed sensor will differ between brands of vehicles. The sensor will be mounted either on or just below the turbo, and will be a screw in unit with two wires.