The oil pressure is zero when the engine is not running. The oil pressure sensor will read the low pressure for a second, when the engine first starts.
turn on ignition, dont start it. hold down brake and throttle pedal fully for about a minute or until light flashes. sorted
That light flashes when there is a malfunction in the sentry key system. You could have the wrong or a failed key.
It's basically the smartlock function. it basically immobilises your car so without the key, you can't start the car. Also I believe it has something to do with central locking.
To reset the service warning light on a 2003 VW Transporter 2.5 TD, turn the ignition to the "on" position without starting the engine. Press the gas pedal fully three times within ten seconds. Turn the ignition off, then start the engine to check if the warning light has reset. If it remains on, repeat the process or consult a professional for assistance.
This is a warning that the brakes are in need of service soon. See your mechanic.
To reset the service engine warning light on a VZ Commodore without a scan tool, you can disconnect the battery by removing the negative terminal for about 15 minutes. Reconnect the terminal and start the engine; the warning light should be off if the issue has been resolved. If the light returns, it indicates an underlying problem that needs to be addressed. Always consult your vehicle's manual for specific instructions or warnings.
Coolant level warning light. It is either your coolant warning light, wiper fluid warning light or low tire pressure warning light.
plug in noid light start car if it flashes its getting power and ground
it is the key if you go get the replcement key car will start
you left your emergency flasher on overnight
This question all depends on which Warning light you are refering to. The Check engine symbol indicates when a system servuce us required. The symbol lights up when the ignition is switched on and goes out shortly after the engine starts to run. If the symbol lights up when driving serivce to the engine management system may be required, the car is still drivable but must be service asap to prevent engine damage. Note if the symbol flashes and the engine cannot be started, turn the iginition off for at least 2 seconds before attempting to start the engine again. The other Symbol is the Emissions light, which looks like an engine. This system is the emission monitoring system, it lights up when the care is turned on and then turns off shortly after starting. If the light stays on you must have your vechile serviced asap, note if the symbol flashes whilst driving reduce your speed and service you vechile asap.
no srry